2
Please Note You may need to remove the door to aid installation. This can be done by
unclipping the hinges (There is a release catch at the back of the hinge).
Operating Instructions
To turn illumination on or off, use the rocker
switch located inside at the top of the cabinet.
Care Instructions
To preserve the high quality finish of your
HiB product, please ensure you regard the
following care and cleaning recommendations:
1. Wipe off all water spillages as soon as
possible
2. Mirrors and glass can be cleaned with a
proprietary cleaner using a so cloth, taking
care not to get excessive cleaner behind the
mirror
3. All other surfaces should be cleaned with
diluted detergent, i.e. washing up liquid,
and a so cloth. Scourers and scouring
agents should not be used, as these may
cause damage to the surface of the product
WEEE compliance
Must not be mixed with general
household waste
Fitting Instructions
1. Position the cabinet in a suitable location,
(according to Fig. 4 on the back page),
ensuring that the domestic electrical mains
supply is within reach of the electrical
connection point of the cabinet. Carefully
mark the position of the top of the cabinet
using a so pencil.
2. Remove the cabinet from the wall and
using a spirit level, mark the position of the
two mounting points (Fig. 1).
3. Before drilling, ensure there are no
hidden cables or pipes behind the
mounting points. Drill the required holes
in the marked positions. If drilling through
tile, use a ceramic drill bit. Insert the wall
plugs level with the surface of the wall. If
fitting to a tiled surface, wall plugs should
be inserted below the tile surface to avoid
cracking. NB. For plasterboard walls,
specialist fixings should be purchased,
available from any DIY or hardware store.
4. This cabinet is provided with an electrical
supply cable already fitted. This cable
should be connected to the household
electrical circuit, and connections should
be made in accordance with the latest IEE
regulations. This is a Class II product and
does not require an earth connection.
Ensure the domestic electrical mains
supply to which the product is being
connected is turned off. Connect the
domestic mains supply (See Fig. 5 on the
back page).
5. Reposition the cabinet into the corner
eusuring the fixing holes line up with the
wall plugs. Screw the cabinet to the wall
using the two screws provided (Fig. 2).
6. Switch the electrical mains supply back on.
7. The hinge can be adjusted in order to
reposition the door correctly. See Fig. 3 - A,
B and C for further information.
