HIK VISION DS-K1T501 User manual

Title:
DS-K1T501 work as wiegand reader
Version:
v1.0
Date:
10/31/2018
Product:
DS-K1T501
Page:
1 of 3
© Hangzhou Hikvision Digital Technology Co.,Ltd. All Rights Reserved.
No.555 Qianmo Road, Binjiang District, Hangzhou 310052, China • Tel: [phone] • Fax: [phone]
E-Mail: [e-mail] •www.hikvision.com
DS-K1T501 work as wiegand reader
Device Info:
K1T501SF firmware version: V1.1.0_build180202
K2604 firmware version: V2.0.4_build180913
Step1: Set dip switch for K1T501SF(instruction available on User manual)
For example, if K1T501SF use as wiegand reader1(control K2604 lock1 entrance), follow front picture
Set dip switch 6 (work as card reader) as ON status. Connect device to controller via wiegand(W0,W1,GND)

Title:
DS-K1T501 work as wiegand reader
Version:
v1.0
Date:
10/31/2018
Product:
DS-K1T501
Page:
2 of 3
© Hangzhou Hikvision Digital Technology Co.,Ltd. All Rights Reserved.
No.555 Qianmo Road, Binjiang District, Hangzhou 310052, China • Tel: [phone] • Fax: [phone]
E-Mail: [e-mail] •www.hikvision.com
Step2: Add card and person info and sync to K2604 access controller.
Step3: Test. Verify card on K1T501SF and check event from ivms-4200 software
Note:
1. If only connect wiegand cable W0, W1 and GND, when swiping card on K1T501, it will not give any prompt when verify
failed or successfully, if all cables(W0, W1, GND, BUZ, OK and ERR) are connected, device will give 2 beeps when verify
successfully, 3 beeps when verify failed.
2. When work in reader mode, device will not upload event to ivms4200 software.

Title:
DS-K1T501 work as wiegand reader
Version:
v1.0
Date:
10/31/2018
Product:
DS-K1T501
Page:
3 of 3
© Hangzhou Hikvision Digital Technology Co.,Ltd. All Rights Reserved.
No.555 Qianmo Road, Binjiang District, Hangzhou 310052, China • Tel: [phone] • Fax: [phone]
E-Mail: [e-mail] •www.hikvision.com
First Choice for Security Professionals
HIKVISION Technical Support