HIK VISION DS-K2600 Series User manual

DS-K2600 Series Controller Connect to RS485 Reader
DS-K2600 Series Controller Connect To RS485 Reader
Operation Process
1) Set reader dip switch for RS485 address.
2) Connect DS-K2600 controller to RS485 reader
3) Check reader LED status
Operation Steps:
1. Set dip switch for RS485 reader.
a) The former 4 dip switch are used to configure RS485 address, address 1 for door 1 entrance, 2 for door1
exit, 3 for door2 entrance, 4 for door2 exit, etc. maximum address 8 for door4 exit.
b) When reader works in RS485 mode, the latter 4 dip switch set as OFF status
DIP Switch status
Access point
Card reader
1000 0000
Door1
Entrance reader 1
0100 0000
Exit reader 2
1100 0000
Door2
Entrance reader 3
0010 0000
Exit reader 4
1010 0000
Door3
Entrance reader 5
0110 0000
Exit reader 6
1110 0000
Door4
Entrance reader 7
0001 0000
Exit reader 8
2. Connect DS-K2600 to RS485 reader
3. Check reader LED status
If connect correct, the LED light on reader should blink in blue color, if in red color it means communication
error happens, please check the wiring or dip switch.

DS-K2600 Series Controller Connect to RS485 Reader
Suitable Models:
Model
Description
DS-K2601
Single door access controller
DS-K2602
Two door access controller
DS-K2604
Four door access controller