HIK VISION DS-K5603-Z User manual

(Simplified) Simplified Edition-Face Recognition Swing Barrier Installation Guide_V1.1-20190215.docx
Hikvision Product Support Team
1
Face Recognition Swing Barrier
Installation Guide
(Simplified Edition)
Date
Content
Person
20180908
Create
Nero
20190215
Translate and Modify
Morgen

(Simplified) Simplified Edition-Face Recognition Swing Barrier Installation Guide_V1.1-20190215.docx
Hikvision Product Support Team
2
Content
Face Recognition Swing Barrier..................................................................................................................................................... 1
1. Wiring.............................................................................................................................................................................. 3
2. Swing barrier study mode........................................................................................................................................ 5
3. Software configuration.............................................................................................................................................. 6
4. Testing ............................................................................................................................................................................ 8

(Simplified) Simplified Edition-Face Recognition Swing Barrier Installation Guide_V1.1-20190215.docx
Hikvision Product Support Team
3
1. Wiring
1）Power cable wiring: connect cable to air switch(L, N and GND)；
NOTE：Power OFF before wiring to ensure safety.
2）Connect interconnecting cable between left and right barriers.

(Simplified) Simplified Edition-Face Recognition Swing Barrier Installation Guide_V1.1-20190215.docx
Hikvision Product Support Team
4
3）Connect DS-K5603-Z to swing barrier.
a. Connect power cable. There is a connecter inside barrier to provide power for face
module(DS-K5603-Z)
b. Connect face module RS232 cable to reserved interface(Black connecter)
White\Green—Black White\Orange—Blue Orange—Yellow
From face device
From barrier 12V power
supply

(Simplified) Simplified Edition-Face Recognition Swing Barrier Installation Guide_V1.1-20190215.docx
Hikvision Product Support Team
5
c. Connect swing barrier and face module to network switch.
There is no need to care about the sequence, it’s a normal switch, so that we can manage face module and
swing barrier in software at same time, to ensure same data in two devices.
2. Swing barrier study mode
1) Power off the device and adjust two swings on a line.
2) Set DIP switch as 10000000, and power on the device
From face
module
From barrier
Connect to PC

(Simplified) Simplified Edition-Face Recognition Swing Barrier Installation Guide_V1.1-20190215.docx
Hikvision Product Support Team
6
3) After study mode finish(swing stopped moving), power off the device, adjust DIP switch as 00000000,
power on device again. Device will open and close one time automatically.
3. Software configuration

(Simplified) Simplified Edition-Face Recognition Swing Barrier Installation Guide_V1.1-20190215.docx
Hikvision Product Support Team
7
1) .Add device（activate in advance）
2) Select K3M200 and enter Remote Configuration, enter page as below and select RS-485
Select 4 from drop-down list and set as front left picture, then select 6 from drop-down list and set other
parameters same as front right picture.
3) Add person from software, include card and face, don’t forget to link face picture to card.
Swing barrier control board K3M200
Face Recognition module：K5603-Z

(Simplified) Simplified Edition-Face Recognition Swing Barrier Installation Guide_V1.1-20190215.docx
Hikvision Product Support Team
8
4) Synchronize person data to swing barrier and face recognition module
4. Testing
Verify card on card reader，barrier will open, after pass the barrier will close.
Verify face on DS-K5603(T)-Z，barrier will open, after pass the barrier will close.