HIK VISION DS-K2600 Series User manual

Title:
How to Initial Access Controller
Version:
v1.0
Date:
7/19/2017
Product:
Access Control Device
Page:
1 of 3
How to Initial Access Controller
Preparation
In this document, the access controller includes DS-K2600 series and DS-K2800 series access controllers.
Notice
1. Please make sure access controllers are powered on before initializing the hardware;
2. Initializing the hardware will restore device to factory, and all parameters what you set will be erased;
3. After initializing, please activate access controllers again by setting a new strong password;
4. For DS-K2600 series access controllers the initial jumper is in the same position, please find it in
access controller mainboard as following pictures:
5. For DS-K2800 series access controllers the initial jumper is in the same position, please find it in
access controller mainboard as following pictures:
Normal Status
Initial Status

Title:
How to Initial Access Controller
Version:
v1.0
Date:
7/19/2017
Product:
Access Control Device
Page:
2 of 3
Mothed
Step 1:
Please jump the jumper from Normal Status to Initial Status;
Step 2:
Please cut off the access controller power suplly, and please restart the access controller after several
seconds, the controller buzzer buzzes a long warning;
Step 3:
After the buzzer stops, please jump the jumper from Initial Status to Normal Status;
Step 4:
Please cut off the access controller power suplly and restart the access controller;
Normal Status
Initial Status

Title:
How to Initial Access Controller
Version:
v1.0
Date:
7/19/2017
Product:
Access Control Device
Page:
3 of 3
First Choice for Security Professionals
HIKVISION Technical Support