Home Styles 88 5134 30 User manual

IMPORTANT NOTE
Carefully remove all the parts from the carton and put
them individually on a soft cloth to prevent scratches
or other damage occuring to the parts.
We have taken great care in the design of this
product and request that you carefully and strictly
follow our assembly instructions to ensure a
completed product as it was designed.
Part List
Home Styles ConsumerAssistance: www.homestyles-furniture.com,
[email protected], 888-680-7460, 877-831-0319
Hardware List
Tools required for assembly : Phillips screwdriver
Hex Wrench
1 Pc.
Small Hex Wrench
1 Pc.
M3.5x 40
Wood Screw
1 Pc. (+1 extra)
88 5134 30
Dining Table
A.
Top
1 Pc.
B.
Top Frame
1 Pc.
D.
Stretcher
1 Pc.
E.
Stretcher
1 Pc.
C.
Leg
4 Pcs.
Tools recommended for assembly : Level
M10x70
Bolt
8 Pcs. (+1 extra)
Steel Plate
4 Pcs.
Spring Washer
8 Pcs. (+1 extra) Flat Washer
8 Pcs. (+1 extra)
M6x15
Head Cap Bolt (small)
4 Pcs. (+1 extra)
M6x40
Head Cap Bolt (large)
4 Pcs. (+1 extra)
Key Wrench
1 Pc.

Assembly Instructions 2
IMPORTANT
* Please keep Hex Wrench in a safe place as you may need to tighten up the Head Cap Bolts in the future.
* Do not tighten up all the screws until each part is properly assembled.
* Use a soft cloth between these parts and the floor.
STEP 2
Attach Stretchers (D) and (E) to
unit with Head Cap Bolts (large)
and Wood Screw. (see Figure 2)
Tighten all Head Cap Bolts.
STEP 3
Turn the table over its’
upright position.
To the level the table,
adjust the adjustable levelers
on the bottom of the legs.
(see Figure 3)
B
E
B
A
B
B
B
C
B
CB
C
B
C
B
D
Wood Screw
Head Cap Bolt (large)
Head Cap Bolt (small)
Steel Plate
Flat Washer
Spring Washer
Bolt
STEP 1
Place Top (A) upside down on a soft cloth.
Attach Legs (C) and Steel Plates to Top Frame (B)
with Bolts, Spring Washers and Flat Washers.
(see Figure 1)
Tighten Bolts only half way.
Attach unit to Top (A) with Head Cap Bolts (small).
(see Figure 1)
Figure 1
Figure 2 Figure 3
/2