Home Styles Orleans 88 5061 601 User manual

IMPORTANT NOTE
Carefully remove all the parts from the carton and put
them individually on a soft cloth to prevent scratches
or other damages occuring to the parts.
We have taken great care in the design of this
product and request that you carefully and strictly
follow our assembly instructions to ensure a
completed product as it was designed.
Part List
Home Styles ConsumerAssistance: www.homestyles-furniture.com,
[email protected], 888-680-7460, 877-831-0319
Hardware List
88 5061 601
Orleans
King Headboard
C.
Post
1 Pc.
B.
Post
1 Pc.
F.
Stretcher
1 Pc.
G.
Rail
17 Pcs.
H.
Upright
3 Pcs.
D.
Stretcher
1 Pc.
E.
Stretcher
1 Pc.
A.
Top
1 Pc.
Hex Wrench
1 Pc.
Small Hex Wrench
1 Pc.
1/4x5/8”
Tapered Head Cap Bolt (short)
17 Pcs.(+1 extra)
1/4x1”
Bolt
14 Pcs.(+1 extra)
Outside Plate
2 Pcs.
Inside Plate
1 Pc.
1/4x2”
Bolt (long)
3 Pcs.(+1 extra)
1/4x1 1/2”
Tapered
Head Cap Bolt (long)
17 Pcs.(+1 extra)
1/4x1”
Tapered
Head Cap Bolt (middle)
2 Pcs.(+1 extra)

Assembly Instructions 2
IMPORTANT
* Please keep Hex Wrench in a safe place as you may need to tighten up the Head Cap Bolts in the future.
* Do not tighten up all the bolts until each part is properly assembled.
* Use a soft cloth between these parts and the floor.
STEP 1
Insert Bolts and Bolts (long) into the pre-drilled
holes of Stretcher (D), then attach 17X Rails (G)
to Stretcher (D) and tighten. (See Figure 1)
Attach Stretcher (E) to unit with Tapered Head
Cap Bolts (long). (See Figure 2)
B
F
G
B
C
B
B
B
D
B
E
Tapered
Head Cap Bolt (long)
Tapered
Head Cap Bolt (short)
Bolt
Bolt (long)
Figure 1 Figure 2
/3
STEP 2
Turn the unit over.
Attach Post (B) to unit with
Tapered Head Cap Bolts (short).
Attach Stretcher (F) to unit with Tapered Head Cap Bolts (short).
Attach Post (C) to unit with Tapered Head Cap Bolts (short).

Assembly Instructions 3
E
HE
HE
H
/3
Inside Plate
Tapered Head Cap Bolt (short)
Tapered Head Cap Bolt (middle)
Tapered Head Cap Bolt (short)
Outside Plate
E
ATapered Head Cap Bolt (short)
STEP 3
Attach Uprights (H) to unit and tighten.
(See Figure 3)
Attach Outside Plates to unit with
Tapered Head Cap Bolts (short) and
Tapered Head Cap Bolts (middle).
Attach Inside Plate to unit with
Tapered Head Cap Bolts (short).
STEP 4
Attach Top (A) to unit with Tapered Head Cap Bolts (short).
(See Figures 4 and 5)
Figure 4
Figure 3
Figure 5