Honeywell 290087.1 User manual

Honeywell Life Safety AS, Postboks 236, 1372 Asker http://www.hls-nordic.com
290087.1-01Page 1 from 2
1. Dismantle the luminaire by sliding the
mounting part as shown in the picture.
5. Install the indications plastic and connect
the cable to the respective connector as
shown in the picture.
6. Follow the next steps (page 2) to
complete the installation.
2. Cut the plastic for cable entry.
3. Connect the cable to the respective
connector as shown in the picture.
4. Refer to the installation manual to
complete the electrical connections and
push carefully the electronics back until
the side plastic reaches its original position.
3
5
LUMINAIRE PREPARATION
2
298100.8
290087.1 Recessed Accessory for ExiLED

Honeywell Life Safety AS, Postboks 236, 1372 Asker http://www.hls-nordic.com
290087.1-01
Page 2 from 2
298100.8
290087.1 Recessed Accessory for ExiLED
A
7. Open a hole.
A(L) = 31cm, B(W)= 7cm
8. Place the illumination sign in to the base.
C(H)= 9cm
B
C
9. Push upwards the base. Make sure that
the retaining tags are not expanded.
10. Fasten the two retaining screws
clockwise and the retaining tags will
expand until the base is securely
installed.
Retaining tags
SUSPENDED CEILING PREPARATION