Honeywell ExiLED 290142 User manual

GB
ExiLED
CBS Emergency Light
Installation:
266mm
132mm
223mm
53mm
ExiLED 25m 366mm
199mm
289mm
53mm
ExiLED 40m
Dimensional Drawings:
Step 2: Install the retaining clip to hold the pictograms.
Step 1: For double sided pictogram, install the appropriate pictograms to both sides, push up
until you hear click sound. For single sided pictogram, there is one blind pictogram in
the package.
Step 3: Dismantle the luminaire by sliding the mounting part as shown in picture. Fasten the
mounting part (with screws from within) to either wall bracket(supplied), ceiling (with
or without supplied spacers), pendulum, wire or flag bracket.
The product contains bracket for wall mounting and spacers for ceiling mounting.
Step 4: Make a hole on a black grommet and pass the mains cables through it. Connect the
mains cables to the terminal blocks: L for live wire, N for neutral and PE for ground.
2
Power supply cables cross section should be 0.8 - 3 mm . Tighten the cable tie around
the cables.
click click click click
21 3
Honeywell Life Safety AS, Postboks 236, 1372 Asker http://www.hls-nordic.com
4

Weight:
Technical description
Part no.:
Lumen output:
o
-30 to 50 C
Up to 95%
Produced in accordance with: EN 60598-1, EN 60598-2-22, EN 55015
EN 61547, EN 61000-3-2, EN 61000-3-3
Ambient Temperature Range:
Maximum Power Consumption:
Operation Voltage: 85-250V AC/DC, 50-60 Hz
150 lm 180 lm
840 gr 1350 gr
1.55W / 1.85VA 1.8W / 2.1VA
290142 290143
ExiLED 25m CBS 230V ExiLED 40m CBS 230V
Relative Humidity:
At the end of their useful life the packaging and product should
be disposed of via a suitable recycling centre.
Do not dispose of with your normal household waste.
Do not burn.
The light source contained in this luminary shall only be replaced by the manufacturer, or his agent,
or a similar qualified person.
NOTE! The light source is non-user replaceable.
IP40
Degress of cover protection:
Technical lifetime (light source): > 100000 hours
6
57
Step 5: Slide the two aluminium parts carefully together.
Step 6: Fasten the two screws (included) as shown in the picture.
Step 7: Fasten the two screws (included) as shown in the picture.
Honeywell Life Safety AS, Postboks 236, 1372 Asker http://www.hls-nordic.com
GB