Hornady Security®electronic components are covered by a one-year warranty
from the date of purchase. See Hornady.com for details.
POWER
1. Open the safe with either the
mechanical override key or a
previously programmed code.
2. Locate the battery compartment
door on the top interior panel.
3. Swing the battery compartment
door open by pressing the tab on
the door.
4. Gently remove the 4-pack battery
carrier from the door and insert
four high-quality AAA batteries.
5. Place the battery carrier back into
the door and close.
Note: Replace all batteries at
the same time. Use high quality
batteries for best performance
PROGRAMMING/RESET
COMBINATION CODE
1. Open the safe with either the
mechanical override key or a
previously programmed code.
Note: The vault ships with
the default code of 1-2-3-4.To
maintain the security of this
product, a new code must be
programmed before using.
2. Locate the program button
inside the safe near the battery
compartment. Press and release
the program button.The light
blinks and beeps two times.
3. Enter the new 4- to 6-digit code.
Press and release the program
button to enter the new code.The
light will blink and beep twice.
4. Re-enter the new 4- to 6-digit
code. Press and release the
program button to confirm the
new code.The light will blink
and beep twice before remaining
on for 6 seconds. After the light
turns off, the safe returns to
normal operation.
5. With the lid open, verify that the new code has been programmed and
is functional by entering the new code.The safe motor should cycle after
each correct entry.
Note: Become comfortable with the operation of your safe before
mounting your safe and storing anything of value inside.
OPEN GUN VAULT BY COMBINATION CODE
Enter the previously programmed 4 to 6 digit code to open the safe.
Note:
• Pressing a button should illuminate the keypad in blue.
• When a correct code is entered, the keypad will turn green and the door
should open.
• If an incorrect code is entered, the keypad will turn blue for 2 seconds and
beep two times.
• After five incorrect entries, the safe will beep and lock out for 2 minutes.
The safe can only be opened by the mechanical key during this time.
LOW BATTERY WARNING
To check the battery level, press any button to illuminate the keypad. If the
battery level is lower than 25%, the keypad will illuminate in both green and
blue.The batteries should be replaced immediately to ensure proper function.
KEYPAD TONES ON/OFF
Press and hold the "1" button for
three seconds to toggle sound ON
and OFF.
Note: Toggling the sound off will
turn the keypad, program and
alarm beeps off. Toggling the sound
on will turn the keypad, program
and alarm beeps on.
Item No.: 95430
Ext. Dimensions: 12.7" x 9.0" x 8.8
Int. Dim.: 11.4" x 8.6" x 6.3"
Weight: 12.8 Lbs
Power: 4 AAA batteries (not included)
