POWER
1. Open the safe with either the
mechanical override key or a
previously programmed code.
2. Locate the battery compartment
door on the top interior panel.
3. Swing the battery compartment
door open by pressing the tab on
the door.
4. Gently remove the 4-pack battery
carrier from the door and insert
4 high quality AAA batteries.
5. Place the battery carrier back into
the door and close.
Note: Replace all batteries at
the same time. Use high quality
batteries for best performance
PROGRAMMING/RESET
COMBINATION CODE
1. Open the safe with either the
mechanical override key or a
previously programmed code.
Note: the safe ships with the
default code of 1-2-3-4.To
maintain the security of this
product, a new code must be
programmed before using.
2. Locate the program button inside
of the safe near the battery
compartment. Press and hold
the program button for 3
seconds. After the green light
blinks and beeps two times,
release the button.
3. Enter the new 4 to 6 digit code.
Press and release the program
button to enter the new code.
The yellow light will blink and
beep twice.
4. Re-enter the new 4 to 6 digit code. Press and release the program button
to confirm the new code.The green light will blink and beep twice before
returning to normal operation.
5. With the lid open, verify the new code has been programmed and is
functional by entering the new code. The safe motor should cycle after
each correct entry.
Note: Become comfortable with the operation of your safe before mounting
your safe and storing anything of value inside.
OPEN GUN VAULT BY COMBINATION CODE
Enter the previously programmed 4 to 6 digit code to open the safe.
Note:
• Pressing a button should illuminate the keypad and green indicator light.
• When a correct code is entered, the green indicator light will blink and
beep 1 time as the door pops open.
• If an incorrect code is entered, the red indicator light will blink and beep
2 times.
• After five incorrect entries, the red indicator light will blink and beep for
the entire 2 minute lockout period.The safe can only be opened by the
mechanical key during this time..
LOW BATTERY WARNING
To check the battery level, press any button to illuminate the keypad. If
the battery level is lower than 25% the yellow indicator light will blink for
approximately 20 seconds.The batteries should be replaced immediately to
ensure proper function.
KEYPAD TONES ON/OFF
Press and hold the "1" button for
three seconds to toggle sound ON
and OFF.
Note: Toggling the sound off will
turn the keypad, program, and alarm
beeps off.Toggling the sound on will
turn the keypad, program, and alarm
beeps on.
