Hunter Products D8010 User manual

D8010 Minnie Mouse Vintage Car
Troubleshooting Guide

Please follow the directions in the attached service guide to check the connections on your ride on. Most times it is a loose plug or switch that causes electric
ride’s to stop working.
Keep in mind the ride will not operate if the power adaptor/charger cable is plugged into the ride, this is a safety feature to ensure a child does not take off while it’s
plugged in and damage it.
Disconnect the charger from the car before trying to operate it.
To rule out a faulty fuse:
1. Under the seat in the battery compartment please disconnect the short cable from the red terminal of the battery.
2. Then disconnect the long cable that comes from the ride on wiring to the fuse
3. Connect this cable directly to the red terminal of the battery.
So what you have left over is the small black fuse and a short cable attached to it that are not connected to the ride. This is bypassing the fuse, try this to see if it is in fact a
faulty fuse.
If you have a ride on that is 18+ months old and after following these directions you cannot get it going we recommend removing the battery and having the battery &
charger tested by a professional.
Batteryworld.com.au offer this service over the counter in your local outlet.

Item#: 8453_D8010
Description: Minnie Retro Car
step1
step2
TROUBLE SHOOTING GUIDE
step1
step3 step4
1. Per above steps to check the forward/revise switch connection
step2

step1(optional) step2 step3
step4 step5
2.Per above steps to check the Porwe Switch and Pedal Switch connection
Tips: Remove the steering wheel first to get more space to operate.

step1 step2 step3
step4 step5 step6
4.per above steps to check the internal wire and plug is
connected, and make sure the fuse is connected

step1 step2 step3
step4
5. per above steps to replace the gearbox
a. push the bottom on the rear driving wheel
b. cut the tape(if) and disconnect the motor/ battery plugs inside
c. remove the gearbox
Please pay attention to safety during installation and disassembly.

MOTOR PLUG –PIN TROUBLESHOOT
No. Pin pushed to side.
When plugged together the pin is not connecting with other plug. Yes. Pin is central.