Hunter Products ZP5118 User manual

THE PACKAGING MUST BE RETAINED SINCE IT CONTAINS IMPORTANT INFORMATION.
5609
PLEASE NOTE: IN CASE OF PRODUCT FAULT DO NOT RETURN THIS PRODUCT TO STORE.
PLEASE CONTACT HUNTER PRODUCTS CUSTOMER SERVICE TOLL FREE NUMBER：1800 224 094

1
L
R
PLEASE NOTE: IN CASE OF PRODUCT FAULT DO NOT RETURN THIS PRODUCT TO STORE.
PLEASE CONTACT HUNTER PRODUCTS CUSTOMER SERVICE TOLL FREE NUMBER：1800 224 094

2
R
L
R
L
PLEASE NOTE: IN CASE OF PRODUCT FAULT DO NOT RETURN THIS PRODUCT TO STORE.
PLEASE CONTACT HUNTER PRODUCTS CUSTOMER SERVICE TOLL FREE NUMBER：1800 224 094

3
PLEASE NOTE: IN CASE OF PRODUCT FAULT DO NOT RETURN THIS PRODUCT TO STORE.
PLEASE CONTACT HUNTER PRODUCTS CUSTOMER SERVICE TOLL FREE NUMBER：1800 224 094
RL
Secure front steering brace A as shown. Secure front steering brace B
as shown.
Secure steering rod to front steering brace A.

4
PLEASE NOTE: IN CASE OF PRODUCT FAULT DO NOT RETURN THIS PRODUCT TO STORE.
PLEASE CONTACT HUNTER PRODUCTS CUSTOMER SERVICE TOLL FREE NUMBER：1800 224 094

•Install seat after battery connection as shown.
Refer to parts list for correct screw to be used.
•Place pre assembled steering assembly over
steering axle and align holes in both steering
assembly and steering axle. Insert steering bolt
11 and fasten until tight.
Move steering from side to side to ensure a
proper fit.
104 Series
18A
125/250Vac 50/60Hz
12
9
10
11
Thermal Fuse
Your Commander is fitted with a thermal overload fuse.
The function of this component is to protect the electrical cir cuit
of your product. If the product is overloaded ( refer maximum
user weight ) or is used on a steep incline ( not recommended )
the thermal fuse will cut power supply to the motors and vehicle
will stop. Thermal fuse will reset within 2 minutes and product
function will resume as normal.
Charging your electric ride on
Battery charging input socket is located at the rear of your Commander as shown in the image below.
Plug charger output socket into input socket on you Commander as shown. Then plug AC adaptor /
Charger into a standard 220V-240V household power outlet. Battery should be charged for no longer
than 15 hours first charge and each charge thereafter 8-12 hours.
Never allow your battery to run completely flat and always place battery on charge if vehicle starts to
show signs of slowing down or erratic motion.
Battery charger used with the toy is to be regularly examined for damage to the cord, plug, enclosure and
other parts, and in the event of such damage it must not be used until that damage has been repaired.
5
PLEASE NOTE: IN CASE OF PRODUCT FAULT DO NOT RETURN THIS PRODUCT TO STORE.
PLEASE CONTACT HUNTER PRODUCTS CUSTOMER SERVICE TOLL FREE NUMBER：1800 224 094

6
PLEASE NOTE: IN CASE OF PRODUCT FAULT DO NOT RETURN THIS PRODUCT TO STORE.
PLEASE CONTACT HUNTER PRODUCTS CUSTOMER SERVICE TOLL FREE NUMBER：1800 224 094

033011
5.
6.