HUUM DROP 4 User manual

ELECTRIC SAUNA HEATER 3–12
APPAREILE DE CHAUFFAGE
ÉLECTRIQUE DE SAUNA
DROP
FR
15–24
[email protected] www.huumsauna.com

3
DROP
ELECTRIC SAUNA HEATER
Installation and operation manual
NB! The following instructions for electrical works must be carried out
NB!
NB! This appliance is not intended for use by persons (including child-
ren) with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for
NB! Children should be supervised to ensure that they do not play with
NB! The installation instructions for appliances for public saunas that
do not have a timer shall state that a pilot lamp showing that the heater
-
requirements for sauna heating appliances and infrared cabins”.
• electric heater;
• installation and operation manual for the electric heater;
•
NB!

4
THINGS TO CHECK BEFORE INSTALLATION
•
• In case there are any uninsulated brick, tile or glass walls in the
added to the sauna room for each such square meter of the wall.
• The suitable output of the heater will be determined based on
• The producer’s warranty guarantee is invalid if the heater and
sauna room have been dimensioned incorrectly!
•
INSTALLATION
Positioning the heater
• The heater must be positioned in such a way that there is a safe
of the heater. See Figure.
• In installing the heater, it must be prevented that people could
have physical contact with the heater or that other dangerous
situations could emerge during the heating process.
•
heater.
• The method of mounting the heater must guarantee that it
should be considered upon installing the heater on the wall.
•
looking from the front.

5
Table 1 ABCDEMIN gap
DROP 4
590 mm
DROP 6
630 mm
DROP 7.5 5.3 in
660 mm
DROP 9 5.9 in
690 mm
Connecting the heater to the power supply
•
controller.
•
power supply.
•
•
• The cable must be secured to the clamp on the cover screw.

6
Table 2 Output Room Amps
A
Circuit Breaker
A
Wire Size
AWG
3
330
6
3
330
3
3
9
3
350
Table 3 Output Room Amps
A
Circuit Breaker
A
Wire Size
AWG
3
3
3
330
5.6
3
330
3
3
NB! It is forbidden to use a non-heat-resistant cable with PVC isolation
•
•
circuit diagram.
•
•
• Install the heater on the wall frame.

7
L2L1
240V 2~
208V 2~
DROP 4.5 kW
DROP 6 kW
L2L1
240V 2~
208V 2~
DROP 7.5 kW
DROP 9 kW
around the heater elements.
• Stack the stones sparsely between the heating elements. When
the stones have been stacked too close to each other, the heating
the sauna.
•
heater.
•
the heating elements. The heating elements must not be visible.
•
as tightly as possible; the surface of the heating elements must
not be visible.
•
user’s responsibility.

8
ATTENTION!
A TOO SPARSELY FILLED STONE CONTAINER CAUSES FIRE HAZARD!
NB!
Before switching the heater on, the insulation resistance might prove
to be lower than the standard.
The reason for that is the moisture seeped into the insulating layer
during storage in the warehouse and transportation. The moisture
Controlling the heater
The output of the heater must remain in the interval determined by
the control panel’s producer. Product other than those for installation
in public saunas, shall be provided with a timer. For appliances for
period of 6 h before any automatic restarting. For other appliances,
the operating period of the timer shall be limited to 6 h, automatic
restarting not being allowed.
NB!

9
SAUNA ROOM
Wall materials and insulating the sauna room
In a sauna with electric heating, all massive heat accumulating wall
the electric heater with a regular output.
The following sauna wall and ceiling construction is considered
•
• the construction is damp proofed with taped aluminium paper or
•
boarding
•
•
ceiling panels at the upper part of the wall panelling.
In order to use the heater with a regular output, it would be practical
boarded according to the method described above.
made for heat resistant walls in the vicinity of the heater.
ATTENTION!
NB!
example, mineral tiles that are installed directly on the surface of the
walls or ceiling might cause the dangerous overheating of the wall or

10
Darkening of the sauna room walls
If you use wood protection products, you may notice that the wall
above the heater darkens before long. The darkening process is also
will not heat to a dangerous level. The highest allowed temperature
Floor of the sauna room
The heater stones in use crumble due to temperature changes.
The pieces and pebbles breaking away from the heater stones are
around the heater.
Ventilation of the sauna
the fresh air into the sauna room from above the heater stones. As an
alternative, the fresh air may be directed in from under the heater.
valve must be installed in the opposite wall from the heater at least

11
WARNING!
• Before turning on the electric heater, always check the sauna
room and heater.
•
with stones.
•
•
•
•
• Never make steam by using a water hose.
•
insulation under the boarding.
• Sauna doors must always open outward.
•
used.
•
•
on the stones.
•
• Sudden cooling after staying in the steam room is not
•
• Keep this information in a secure place.
•
elements.

12
WARRANTY
Buyer is obligated to read user manual and follow instructions and
following instructions and requirements will void warranty.
If any defects are found on the product, where manufacturer can be
the product. Purchase receipt needs to be presented when warranty
demands are made.
• Warranty applies only to electric heaters that have been used
• according to the manual.
• NB! Warranty does not cover heating elements. They are
• considered as consumable parts.
• Warranty does not cover wear that occurs from natural usage
Warranty does not cover defects or wear caused by planned
use.
•
• damage or defects are caused by transportation or other
• actions not controlled by manufacturer.
• product has been damaged by carelessness or overload
• product has not been installed correctly
•
• warranty period is over
• product is not complete
All demands shall be presented directly to reseller or using