HUUM STEEL User manual
3
STEEL
ELECTRIC SAUNA HEATER
Installation and operation manual
NB! The following instructions for electrical works must be carried out
NB!
NB! This appliance is not intended for use by persons (including chil-
dren)with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for
NB! Children should be supervised to ensure that they do not play with
NB! The installation instructions for appliances for public saunas that
do not have a timer shall state that a pilot lamp showing that the heater
-
requirements for sauna heating appliances and infrared cabins”.
• electric heater;
• installation and operation manual for the electric heater.
NB!
4
THINGS TO CHECK BEFORE INSTALLATION
•
• In case there are any uninsulated brick, tile or glass walls in the
) of the wall.
• The suitable output of the heater will be determined based on
•
•
4
6 X 40
6 X 40
A A
B
H
3.5 *
Min 47.3 /
1200 mm
34.4
875 mm
5
Table 1 Output kW Room Amps
ACircuit breaker
AWire size
AWG
3.5
3.5 3
3
6 6 3
3
30
9 9 3
3
37.5 50
3
3
50 6
Table 2 Output kW Room Amps
ACircuit breaker
AWire size
AWG
3.5
3
3
6 3
3
30
9 6.75 3
3
7.9 3
3
50
Table 3 A B H Width/
Depth Weight
3.5 50 mm 975 mm
6
50 mm 975 mm
33 lb
9
975 mm
33 lb
975 mm
33 lb
6
INSTALLATION
Positioning the heater
• The heater must be positioned in such a way that there is a safe
of the heater. See Table 3.
•
situations could emerge during the heating process.
•
•
the heater.
Connecting the heater to the power supply
• A method to disconnect all poles from the mains (a circuit
breaker) must be installed on the power circuit before the sauna
controller.
•
power supply.
•
• It is recommended to connect the unit to the mains without an
earth-leakage circuit breaker.
•
•
NB! It is forbidden to use a non-heat-resistant cable with PVC isolation
7
•
•
circuit diagram.
•
•
L1 L2 L2L1
240V 2~
208V 2~
240V 2~
208V 2~
STEEL 3.5 kW
STEEL 6 kW
STEEL 9 kW
STEEL 10.5 kW
•
process.
•
• Stack the stones sparsely between the heating elements. If the
of the sauna.
•
heater.
•
•
responsibility.
ATTENTION!
NB!
8
First-time use of the sauna heater
to be lower than the standard. The reason for that is the moisture
seeped into the insulating layer during storage in the warehouse and
transportation.
Controlling the heater
the control panel’s producer.
Product can be used only with controlunit with timer function.
Including other than those for installation in public saunas, shall be
and similar locations, the operating period of the sauna heater
automatic restarting. For other appliances, the operating period
of the timer shall be limited to 6 h, automatic restarting not being
allowed.
Guard rails
• It is recommended to construct a guard rail around the heater.
We recommend using materials with low heat capacity and bad
•
ATTENTION! IF THE HEATER IS INSTALLED CLOSER TO FLAMMABLE
CONSTRUCTIONS THAN AT THE DISTANCE OF THE MINIMAL REQUIRED
PROTECTION BELT IT MAY CAUSE A FIRE HAZARD!
9
SAUNA ROOM
Wall materials and insulating the sauna room
surfaces (brick, glass brick, rendering etc.) must be insulated to use
the electric heater with a regular output.
The following sauna wall and ceiling construction is considered
•
• the construction is damp proofed with taped aluminium paper or
•
boarding
• -
•
ceiling panels at the upper part of the wall panelling.
In order to use the heater with a regular output, it would be practical to
ATTENTION!
NB!
mineral tiles that are installed directly on the surface of the walls or ceiling
10
Floor of the sauna room
The heater stones in use crumble due to temperature changes.
The pieces and pebbles breaking away from the heater stones are
around the heater.
Ventilation of the sauna
•
the heater stones.
•
heater.
•
•
•
11
WARNING!
• Before turning on the electric heater, always check the sauna
room and heater.
•
with stones.
•
• Do not touch a working heater, it causes burns.
•
• Only tap water may be used for making steam.
•
•
insulation under the boarding.
• Sauna doors must always open outwards.
• Do not use the sauna for a purpose it is not intended for.
• Do not install more than one heater into the sauna room.
•
onto the stones.
•
• Sudden cooling after staying in the steam room is not
• Enjoy the sauna as long as it is comfortable for you.
• Keep this information at a safe place.
•
elements.
12
WARRANTY
Buyer is obligated to read user manual and follow instructions and
requirements presented. Damage to the product caused by not
If any defects are found on the product, where manufacturer can be
product. Demands must be made not later than 5 years after buying
the product. Purchase receipt needs to be presented when warranty
demands are made.
Warranty Terms
•
according to the manual
•
considered as consumable parts.
•
•
•
• damage or defects are caused by transportation or other
actions not controlled by manufacturer;
•
• product has not been installed correctly;
•
•
• product is not complete.
All demands shall be presented directly to reseller or using
Other manuals for STEEL
4
Table of contents
Other HUUM Electric Heater manuals
