hygena 314/9195 User manual

323/4550
elbaTerauqSrevaSecapSnedooW
Important –Please read these instructions fully before starting assembly
Assembly Instructions -Please keep for future reference 314/9195
Issue 1 - 25/10/14
ehtllac,strapgnissimrodegamadevahroplehdeenuoyfI Customer Helpline:
Argos = 0345 6400800
Dimensions
Width - 100cm
Depth - 100cm
Height - 76cm

1
Safety and Care Advice
Important –Please read these instructions fully before startingassembly
• Check you have all the
components and tools listed on
the following pages.
• Remove all fittings from the
plastic bags and separate them
into their groups.
• Keep children and animals
away from the work area, small
parts could choke if swallowed.
• Make sure you have enough
space to layout the parts before
starting.
• During assembly do not stand
or put weight on the product,
this could cause damage.
• Assemble the item as close
to its final position (in the same
room) as possible.
• Assemble on a soft level
surface to avoid damaging the
unit or your floor.
• Parts of the assembly will be
easier with 2 people.
• To reduce
the likelihood of
damaging your
product please
ensure that your
power drill is set on a low torque
setting.
• Only clean using a damp cloth
and mild detergent, do no use
bleach or abrasive cleaners.
• From time to time check that
there are no loose screws on
this unit.
• This product should not be
discarded with household waste.
Take to your local authority
waste disposal centre.
Care and maintenance
• Assemble all parts and bolts
loosely during assembly, only
once the product is complete
should you fully tighten the bolts
• Regularly check and ensure
that all bolts and fittings are
tightend properly.
Handy Hints

Components - Panels
Please check you have all the panels listed below
2
2
13
4
Upper supporting bar
(83 x 7cm)
Upper supporting bar
(83 x 7cm)
Leg supporting bar
(83 x 6.4cm)
Leg supporting bar
(83 x 6.4cm)
Table leg x 4
5Table top
6
(74.5 x 6.5cm)
Components - Fittings
Please check you have all the fittings listed below
70mm Bolt x 4
A
80mm Screw x 8
B
Note: The quantities below are the correct amount to complete the assembly. In some cases more fittings
may be supplied than are required.
C
Plain washer x 8
Nut X 8
D
G
EF
Connector x 8 Cap x 4
Wooden dowel x 18
Ruler - Use this ruler to help correctly identify the screws
0 5 10 15 20 25 30 35 40 45 50 55 60 65 70 75 80 85 90 95 100 110 115 120 125 130 135 140 145 150 155 160 165 170
105
H
Wrench X 1
I
Hex key X 1
smaller holes bigger holes
If you have damaged or missing components, call the
Customer Helpline: Argos = 0345 6400800
(100 x 100cm)
The bolts length is measured from the head to the point
(70mm bolt shown).

Assemble leg frame
Step 1
Assembly Instructions
a
a:
b:
3
5
:Fix screws and insert
wooden dowels into
legs as shown.
B
G
5
E
C
D
5
4
1
G
G
B
G
B
G
G
Two people are needed
here.
b: Attach leg supporting
bar and upper
supporting bar to table
legs ,then fix with
connectors , plain
washers and nuts as
shown.
E
C D
4
1
5
Important note: Do not fully tighten bolts at this stage.
E
C
D
5

Step 1 - continued
Assembly Instructions
cc:
d:
4
:Attach leg supporting
bar to the assembled
unit by using wooden
dowels as shown.
3
2
3
G
GG
Attach upper supporting
bar to the assembled
unit as shown.
2
d:Attach legs to the
assembled unit,then fix
with connectors , plain
washers and nuts
E
CDECD
5
5
5
Important note: Do not fully tighten bolts at this stage.

Step 2
Assembly Instructions
Step 3
Assemble table top
Place table top upside
down on a clean surface,
fix the assembled leg
frame onto table top using
bolts
6
6
Two people are needed
here.
A
Cover the holes by using
caps as shown.
Assemble cap
Assemble is complete
F
If you need help or have damaged or missing parts, call the Customer Helpline:
Argos = 0345 6400800
F
A
Important note: After all the parts are positioned, you
can now fully tighten all bolts fixed on previous steps.