hygena Amparo 633/3290 User manual

633/3283
633/3300
Amparo Table
Dimensions
Width - 85cm
Length - 85cm
Height - 76cm
Issue 1 - 02/04/11
Important – Please read these instructions fully before starting assembly
Assembly Instructions - Please keep for future reference 633/3290
If you need help or have damaged or missing parts, call the Customer Help line: 0845 6400800

1
Safety and Care Advice
Important – Please read these instructions fully before starting assembly
• Check you have all the
components and tools listed on
page 2.
• Remove all fittings from the
plastic bags and separate them
into their groups.
• Keep children and animals
away from the work area, small
parts could choke if swallowed.
• Make sure you have enough
space to layout the parts before
starting.
• Do not stand or put weight on
the product, this could cause
damage.
• Assemble on a soft level
surface to avoid damaging the
unit or your oor.
• Only clean using a dry cloth,
do not use bleach or abrasive
cleaners.
• From time to time check that
there are no loose screws on
this unit.
• This product should not be
discarded with household waste.
Take to your local authority
waste disposal centre.
Care and maintenance
• We do not
recommend the
use of power
drill/drivers for
inserting screws,
as this could damage the unit.
Only use hand screwdrivers.
• Dispose of all packaging
carefully and responsibly.

Table leg x 4
(74 x 19cm)
Components - Panels
Please check you have all the panels listed below
2
If you have damaged or missing components,
call the Customer Helpline:
0845 6400800
Table top (85 x 85cm)
2
Components - Fittings
Please check you have all the ttings listed below
17mm Bolt x 16
A
Nut x 8
B
Note: The quantities below are the correct amount to complete the assembly. In some cases more ttings
may be supplied than are required.
1Connecting plate x 4
(10 x 10cm)
3
C
Wrench x 1
Hex Key X 1
D

Assembly Instructions
Assemble table top
Place table top 2
upside down on a clean,
at surface.
Fix connecting plate 3
onto the table top using
bolts Aby using Hex key
D
Note: The direction of
the arrows should be
pointed outward as
shown in the gure.
Step 1
A
A
A
A
3
2
3
3
3
BB
Assemble legs
Position leg 1over the
connecting board and
secure using nuts Bby
using wrench C.
Note: Make sure the
direction of the table
legs is the same as
shown in the gure
during assembling.
Assembly is complete.
2
1
1
1
1
If you need help or have damaged or missing parts, call the Customer Helpline: 0845 6400800
Step 2