Intermec PB41 User manual

Installation
Installing 802.11b
Radio Card in the
Instructions
PB41 Printer

2 Installing 802.11b Radio in PB41 Printer Instructions
Packing List
Checktoensurethatyoureceivetheseitems:
SIntermecRPB41A27040 or PB41A27042 (4-inch thermal
belt ) Printer with 802.11b radio
S802.11b Radio Card (taped to the inside of the printer box)
Introduction
Your PB41 Printer with an 802.11b radio has been configured
at the factory. FCC mandates that the radio card not be
installed for shipment. The following information guides you
through the process of installing the radio card.
The radio card is packed separately in a static plastic bag
taped to the inside of the printer box.
Installing 802.11b Radio Card
Before installing the 802.11b Radio Card ensure
that the protective battery tab strips are in place
or remove the batteries before installing the radio
card in your PB41 Printer.
1Remove the radio card cap.

3
Installing 802.11b Radio in PB41 Printer Instructions
2With the logo facing down, insert the radio card between the
foam and the radio card strap.
3Carefully push the card into the connector until it is fully
seated.
4Replace the radio card cap.
5Install the battery packs.

4 Installing 802.11b Radio in PB41 Printer Instructions
Corporate Headquarters
6001 36th Avenue West
Everett, Washington 98203
tel [phone]
fax [phone]
www.intermec.com
*962000038A*
PN: 962000038A
Installing 802.11b Radio in PB41 Printer Instructions February 2004
U.S.A.
E2004 by Intermec Technologies Corporation. All rights reserved.