Intermec PW50 User manual

The handstrap (P/N 825-196-xxx) provides you with a convenient way to carry your
PW50 printer. The handstrap kit contains these items:
•Handstrap accessory
•These instructions
To attach the handstrap
1Release the strap from the adjuster, and remove the strap from the VELCRO
pad.
2Insert the strap through the PW50 and VELCRO pad. Make sure the D-ring and
adjuster are oriented as shown at the top of the PW50.
PW 50 Handstrap Instructions
Note: VELCRO is a trademark of Velcro Industries B.V.
Strap
D-ring
Adjuster
VELCRO pad

Worldwide Headquarters
6001 36th Avenue West
Everett, Washington 98203
U.S.A.
tel [phone]
fax [phone]
www.intermec.com
©
2008 Intermec Technologies
Corporation. All rights reserved.
PW50 Handstrap Instructions
*943-159-001*
P/N 943-159-001
3Place the strap on the VELCRO pad, and route the strap through the adjuster
and D-ring as shown.
4Close the VELCRO pad over the strap. You are now ready to use the printer with
the handstrap.
5(Optional) Install another handstrap on the other side of the PW50.
Strap
D-ring
VELCRO pad
Adjuster