3
2
P429/2 - DELTA P429/2 - DELTA EN
BC
12
D
12
8 + 10 mm
A
OPERATING POSITION
Open the rollator into operating position.
NB. Always check that the safety catch is in
locked position
FOLDING
1. Pull the safety catch upwards - backwards.
2. Fold the rollator.
NB.Beawareoftheriskofcrushingbetween
the parts of the frame.
BRAKES
Apply the brakes by pulling both brake
handles upwards.
PARKING BRAKE
Press the brake handles carefully downwards
to apply the parking brakes. A distinct click
indicates that the brake is in the correct
position. It is important that both the brakes
are put into parking position when they are
to be used. To release the parking brake, pull
the brake handle upwards.
ADUSTMENT OF BRAKE
EFFECT
Two setting screws, one in the brake lever
and one in the middle of the brake cable
adjust the tension of the brake and the app-
lication of the brake to the user’s capability.
The braking power increases and the move-
ment required in the brake lever is reduced
when the setting screws are loosened.
NB. Make sure to tighten the lock nuts after
adjustment.
HANDLEBARS
NB. The handlebars must point directly backwards
when using the rollator. Under no circumstances
should they be angled outwards. The vertical line
in the knurling must be located in the middle of the
indentation in the frame, see picture A.
To adjust the height of the handles: Undo the
locking levers and adjust the handles to a suitable
height. NB. The handles must never be set above
their highest position, indicated by the knurling on
the tubes.
- Tighten the locking levers, which should then
be adjusted so that they point downwards. (The
locking levers can be freely turned by first pulling
them outwards). Check that the handles are set at
the same height. The handles should normally be
positioned at wrist height.
ACCESSORIES
B) Fitting the basket.
C) Fitting the tray.
D) Fitting the bag.
ASSEMBLING
Before the rollator is assembled remove plastic caps
in the side tubes.
Open the rollator into operating position (see
below).
1. Fit the locking lever with the bolt. The locking
lever with the washer shall be installed on the
outside. Ensure that the head of the bolt slots
into the recess on the fitting.
2. Insert the handle tubes into the side uprights and
tighten the locking levers. These must be pointing
downwards during use.
SAFETY
-The rollator must be fully unfolded when
used as a walking support. NB. Only to be used as a
walking support.
- Exercise caution on sloping ground.
- Do not go up or down stairs with the rollator.
- Do not use the rollator on an escalator.
- Exercise caution when there is a heavy load in
the basket.
- Loads should be transported solely in the
basket, bag or on the tray. Max. overall load in
the basket and on the tray is 5 kg. Max. load in
the bag 5 kg.
- The handlebars must not be angled outside the
marked position as this reduces the rollator’s
lateral stability, see figure A.
