JABSCO 17860 Series User manual

Model 17860-SERIES
Model 17860 SERIES
FLAT TANK ENGINE OIL
CHANGE SYSTEM
FEATURES
Pum Body: Polypropylene
Dia hragm: *Geolast®, oil resistant
Valves: **Viton®, oil resistant
Motor: 12V/24V DC with integral power
switch
Receiver: Plastic with 3.5 Gal. (13.2L)
(maximum) capacity tank
Battery Leads: 7 ft. (2.1m) with alligator clips
Suction Tube: 8 ft. (2.4m), oil & heat resistant
Dimensions:
Weight: 3.5 lb (1.6 kg)
OPERATING INSTRUCTIONS
1. Run the engine for approximately 5 minutes to heat oil
to approximately 160°F (71°C), then shut off
engine prior to oil removal.
2. Insert 1/4" (6 mm) tube into pump inlet port and be
sure that it is securely in place.
3. Open the vent cap located on hose retainer strap,
vent cap must be opened to allow tank to vent air.
4. With the pump switch in the off position (to avoid
sparks), clamp the power-leads’ alligator clips to a
12V DC battery (red to positive; black to negative).
5. With the engine off, remove the dipstick, and insert
the 1/4" (6 mm) oil change probe through the dip-
stick tube until it contacts the bottom of the oil pan. It
may help to measure the probe against the dipstick,
add an inch and mark the probe. Do not push the
probe too far into the dipstick tube or it may curl up
and out of the oil. It may be useful to tape the probe
in place during evacuation.
6. To evacuate the oil, switch on the pump using the
rocker switch at the rear of the motor. Watch for flow
in the probe. If no flow appears in 15 seconds, check
the probe for sediment blockage. Clean the probe
and reset it 1/4" (6 mm) off the pan bottom.
7. The pump will speed up when the oil has been removed.
An average 5 Quart (5 liters) oil capacity engine will take
around 10 minutes to drain.
8. Switch off pump before removing alligator clips from
the battery, to avoid sparks.
9. Remove probe from dipstick tube while wiping with a
rag to prevent oil drips.
10. To empty the container, unscrew the pour cap and
pour the oil into a suitable container for
disposal/recycling.
11. For extended storage, flush pump with water based
degreaser solution.
NOTICE: Always recycle used oil in compliance with
federal and local legislation. andle petroleum products
in an environmentally responsible manner.
*Geolast is a registered trademark of Monsanto.
**Viton is a registered trademark of du Pont de Nemours & Co.
Model Amp Fuse
Number Voltage Draw Size
17860-0012 12 45
17860-0024 24 3 5
Explosion hazard. Motor switch must be in
"OFF" position when connecting and
disconnecting alligator clips to battery terminal
and ground. The switch in an "ON" position can
cause an electrical spark which can result in
explosion. Injury or death can occur. 
WARNING
!
Explosion hazard. Take necessary precautions
to ventilate area around battery of potentially
explosive gases.Continue ventilation during
oil changing procedure. Failure to do so can
result in explosion. Injury or death can occur.
WARNING
!

THE PR DUCTS DESCRIBED HEREIN ARE
SUBJECT T THE JABSC NE YEAR LIMITED
WARRANTY, WHICH IS AVAILABLE F R Y UR
INSPECTI N UP N REQUEST.
© Copyright 2008, ITT Corporation Printed in U.S.A. All Rights Reserved Form: 950-0095 Rev. B 01/2009
Part
Key Description Qty. Number
1 Cap 1 17864-0000
2 Pump 12V 1 17869-0012
Pump 24V 1 17869-0024
3 Tank 1 17866-0000
4 Hose 1 17867-0000
5 Bag (For Hose, Not Shown) 1 17868-0000
Burn Hazard. Heated oil can cause burns.
Wear protective gloves, clothing and safety
glasses during the oil change process.
Failure to do so may result in personal injury.
WARNING
!
1
3
4
2
For quicker oil changes, start engine
and run for 5 minutes to heat the oil.
Remove the dipstick and insert the
suction probe.
Attach the power cord clips to the
engine’s battery.
Red = Positive, Black = Negative
Activate pump with switch on motor to
drain crankcase.
1
2
3
4
KEY
U.S.A.
Flojet
666 E. Dyer Rd.
Santa Ana, CA 92705
Phone: [phone]
Fax: [phone]
UNITED KINGDOM
ITT Corporation
Bingley Road, oddesdon
ertfordshire EN11 OBU
Tel: [phone]
Fax: [phone]
JAPAN
N K Jabsco Company Ltd.
3-21-10, Shin-Yokohama
Kohoku-Ku, Yokohama, 222
Tel: [phone]
Fax: [phone]
GERMANY
Jabsco Gmb
Oststrasse 28
22840 Norderstedt
Tel: [phone]
Fax: [phone]
ITALY
ITT Corporation
Via Tommaseo, 6
20059 Vimercate, Milano
Tel: [phone]
Fax: [phone]