JCROffroad JT Configuration guide

Thank you for purchasing from JcrOroad! Checkout our website, www.jcroroad.com for other great o-road
products. Be sure to rate and review our product online. If you have any questions or are missing parts, please
don’t hesitate to call us at 269-353-1184!
Please read the mounting instructions below carefully before attempting to install.
Be sure to check out the install video on the product page, if available.
JT
BED FRONT MOLLE
PANEL
INSTALL INSTRUCTIONS

INCLUDED HARDWARE
4x
25mm M6
Button Head
14x
5/16”-18 X 5/8"
Button Head
14x
5/16”-18
Serr. Flange Nut

INCLUDED PARTS
1x 2x
4x 2x

1Start by attaching the MOLLE panels together using the
5/16”-18 X 5/8” bolts and 5/16”-18 serr. flange nuts. It doesn’t matter
which panel goes on top of the other, that is up to your preference. Just
make sure that the middle panel is flipped so that the JCR logo is legible,
and the side panels are flipped so that the cut out portion is on the
outside, bottom corners. Now is the best time to attach any mounts you
plan on using to the panels because it can be hard to access the back of
the panels once they are installed.
ASSEMBLY

2Next, loosely attach the side mounts to the back of the side panels using
the 5/16”-18 X 5/8” bolts and 5/16”-18 serr. flange nuts. Make sure that
the side with the two slots is against the back of the panel and the side
with the one slot is sticking out towards the tailgate. Then, remove the
small swiveling tie down rings by the front of the bed from both sides.
These will be used later to fasten the panels into place.
ASSEMBLY

3Next, loosely mount the four top mounts to the holes in the front of the
bed. If you do not have the trail rail, you can simply fasten them into place
using the provided 25mm M6 bolts. If you do have the trail rail, you will
need to remove it and then reinstall it with one of the mounts behind each
of the four holes in it using the factory hardware. The slotted end is what
gets bolted into the bed.
ASSEMBLY
4Once the brackets are in place, loosely mount the MOLLE panel to them
using the 5/16”-18 X 5/8” bolts and 5/16”-18 serr. flange nuts.

5Next, reinstall the tie down rings with the side mounts between the
washer on the tie down bolt and the bed. Leave it loose for now.
ASSEMBLY
6Finally, with everything roughly in place, position the panels however you
would like them and go back and tighten all the bolts that were le loose.
Try to keep the panels as close to vertical as possible.