JCROffroad JK WRANGLER Configuration guide

JK WRANGLER
FRONT DOOR
MOLLE PANEL
INSTALL INSTRUCTIONS
Please read the mounting instructions below carefully before attempting to install.
Check out the install video on the product page for factory rack disassembly.
Thank you for purchasing from JcrOroad! Checkout our website, www.jcroroad.com for other great o-road
products. Be sure to rate and review our product online. If you have any questions or are missing parts, please
don’t hesitate to call us at 269-353-1184!

INCLUDED HARDWARE
12x 12x 8-15 X 3/4 PAN PHIL
Button Head
.257” ID X .500 “ OD X.375”
Nylon Spacer

INCLUDED PARTS
2x

ASSEMBLY
1Before installing, you will have to decide whether or not you want to cut
the net out of the factory door pocket. If you do, simply cut the netting as
close to the edge as possible and pull it out of the door.
2Next, place the panel over the frame of the pocket and align the two
circular cutouts in the panel up with the screw cutouts in the door. With
it positioned how you like it, use something to make a mark on the door
through each of the holes. It is easiest to do this with an awl or something
similar so that the screws have a starting point.
3With the holes marked, start threading the provided screws into each
marked location with a screwdriver and back them back out. This will make
the panel easier to install.
4Finally, install the panel into the door using the provided screws along with
the provided spacers between the panel and the door.

Please read the mounting instructions below carefully before attempting to install.
Check out the install video on the product page for factory rack disassembly.
Thank you for purchasing from JcrOroad! Checkout our website, www.jcroroad.com for other great o-road
products. Be sure to rate and review our product online. If you have any questions or are missing parts, please
don’t hesitate to call us at 269-353-1184!
JK WRANGLER
REAR DOOR
MOLLE PANEL
INSTALL INSTRUCTIONS

INCLUDED HARDWARE
8x 8x 8-15 X 3/4 PAN PHIL
Button Head
.257” ID X .500 “ OD X.375”
Nylon Spacer

INCLUDED PARTS
2x

ASSEMBLY
1Before installing, you will have to decide whether or not you want to cut
the net out of the factory door pocket. If you do, simply cut the netting as
close to the edge as possible and pull it out of the door.
2Next, place the panel over the frame of the pocket and align the panel with
the trim of the factory door pocket. With it positioned how you like it, use
something to make a mark on the door through each of the holes. It is
easiest to do this with an awl or something similar so that the screws have
a starting point.
3With the holes marked, start threading the provided screws into each
marked location with a screwdriver and back them back out. This will make
the panel easier to install.
4Finally, install the panel into the door using the provided screws along with
the provided spacers between the panel and the door.