JCROffroad REAR MOLLE PANEL Configuration guide

Thank you for purchasing from JcrOroad! Checkout our website, www.jcroroad.com for other great o-road
products. Be sure to rate and review our product online. If you have any questions or are missing parts, please
don’t hesitate to call us at 269-353-1184!
Please read the mounting instructions below carefully before attempting to install.
Be sure to check out the install video on the product page, if available.
4TH GEN RANGER
REAR MOLLE PANEL
INSTALL INSTRUCTIONS

INCLUDED HARDWARE
8x8x
5/16”-18 X 5/8"
Button Head
5/16”-18
Serr. Flange Nut
3/8”-16 X 1”
Button Head
3/8”-16
Serr. Flange Nut
25mm M8
Flanged Hex Head
25mm M6
Button Head
4x
4x
4x
2x

INCLUDED PARTS
1x
1x 1x
1x
2x 2x

1Start by loosely attaching the two panels as well as the rear bracket using
the 5/16”-18 X 5/8” button heads and 5/16”-18 serr. flange nuts. The front
panel should sit towards the inside when installed, and the rear panel
should sit between the front panel and the bracket. The larger cutout in
the front panel and the curved cutout in the rear panel both go on the
bottom.
ASSEMBLY

2Once the panels are assembled, install the bottom mount into the factory
threaded holes using the M8 bolts. The horizontal slot should be towards
the ground. If you have a spray in bed-liner, you may need to tap the holes
using a M8 X 1.25mm tap.
ASSEMBLY
3Next, loosely assemble the upper mounts as shown below. Then, remove
the plastic plugs from the bedside and insert the flat washer into the
exposed holes. Once the flat washer is sitting in the hole vertically, lightly
pull out on the rectangular bracket and tighten it into place.

4Finally, mount the panels to the bedside and mounts. The front and back
mount directly to the bedside using M8 bolts and M6 bolts respectively.
If you have a spray in bed-liner, you may need to tap these holes as well.
The mounts attach to the panels using 5/16”-18 X 5/8” button heads and
5/16”-18 serr. flange nuts.
ASSEMBLY