JCROffroad JTRWP User manual

Thank you for purchasing from JcrOroad! Checkout our website, www.jcroroad.com for other great o-road
products. Be sure to rate and review our product online. If you have any questions or are missing parts, please
don’t hesitate to call us at 269-353-1184!
Please read the mounting instructions below carefully before attempting to install.
Be sure to check out the install video on the product page, if available.
JEEP GLADIATOR JT (2020+)
REAR WINDOW MOLLE
PANEL
INSTALL INSTRUCTIONS

INCLUDED HARDWARE
20x 20x
1/4”-20 x 1/2”
Button Head
1/4”-20
Flange Nut
4x
M8 x 1.25mm x 25mm
Heax Head
INCLUDED BOLT PACK(S) 045-0168
Note: Some Victory 4x4/JCR Oroad/SquatchProof products share hardware kits. Any extra hardware you may
recieve that is not listed above can be reurposed or discarded.

INCLUDED PARTS
1L/1R
4x
1L/1R
1x

DISASSEMBLY
1. To start you will need to fold your back seats down for better access to
the hard top bolts. Once the seats are down, remove all (4) of the hard top
bolts, as shown below.

ASSEMBLY
2. With the (4) hard top bolts removed, you can take the (4) provided lower
brackets and M8 hex heads and install them as shown in the orientation
below, replacing the factory hard top bolts with the new M8 hex heads.

ASSEMBLY
3. You can now take the (3) panel pieces and assemble them together using
(8) of the provided 1/4”-20 button heads and flange nuts, as shown in the
orientation below.

ASSEMBLY
4. With the panel now assembled, take (8) more of the provided 1/4”-
20 button heads and flange nuts, and install the panel to the (4) lower
mounting brackets that were previously installed, as shown in the
orientation below.

ASSEMBLY
5. Now that the panel is secure to the bottom mounting brackets, take the
last (2) provided top backets and the last (4) of the 1/4”-20 button heads
and flange nuts and bolt them to the panel in the upper corners of each
side, as shown in the orientation below. Make sure that the brackets are in
front of the panel and the top flanges are out. Leave these hand tight for
now so you have some adjustment in the next step.

ASSEMBLY
6. With the top brackets on the panel, you will now need to remove the
factory bolt in the roll cage that the moutning hole lines up with. Once
the bolt is removed, you will be re-using the same factory bolt though the
bracket to hold it in place, as shown below.

ASSEMBLY
7. Make sure all of you hardware is fully tightend to complete your install. And
that’s it! Now load up your Molle Panel with your desired equipment such
as flashlights, recovery gear, or first aid supplies and hit the trail prepared!
Visit us at www.jcroroad.com to check out other options for made-in-the-
USA storage and armor, and follow us on Facebook and Instagram.