JCROffroad MOLLE Configuration guide

Thank you for purchasing from JcrOroad! Checkout our website, www.jcroroad.com for other great o-road
products. Be sure to rate and review our product online. If you have any questions or are missing parts, please
don’t hesitate to call us at 269-353-1184!
Please read the mounting instructions below carefully before attempting to install.
Be sure to check out the install video on the product page, if available.
6TH GEN BRONCO
OVERHEAD
MOLLE PANEL
INSTALL INSTRUCTIONS

INCLUDED HARDWARE
8x
1/4"-20 X 3/4"
Button Head
8x
1/4"-20
. Flange Nut

INCLUDED PARTS
1x
1x
1x
1L/1R

1Before starting the installation, you will need to some disassembly in your
vehicle. Start by removing the sun visor catches which are held in place by
one bolt in the inside of each. This requires a T20 torx bit.
ASSEMBLY
2Next, gently but firmly apply downward pressure on the top of the
overhead console in order to pull it out of its clips (circled below). Once it is
hanging down you will have room to access the area behind it.

4With everything out of the way, you will be able to see the bolts holding
the roof latches in place. Remove the inner two bolts using a T50 torx bit
and install the front mounting bracket into those holes using the factory
hardware. The bracket should be oriented so that the cutout is on the top
and to the right of center. Before tightening it into place, push it all the
way up so it is tight to the metal on the windshield frame.
ASSEMBLY
3For the overhead console to be able to snap back into place later, you will
need to trim roughly 1/4” from the top edge of the plastic. Simply cut a
straight line across, just above the bend radius as shown below.

6With both side mounts loosely in place, mount the cross bar between
them, from the bottom, using the provided 1/4”-20 bolts and serr. flange
nuts.
ASSEMBLY
5Next, loosely install the side mounting brackets. The hooked side of each
slides into the slots in the top of the roll bar just behind the front seats. It
can then be bolted into the factory threaded hole that lines up with the
hole in the bracket using the hardware that is already there. To remove
these bolts you will need an 8mm socket. Each side mount should be
oriented so that the hook is in the slot and the slotted flange is towards
the front of the vehicle.
PASSENGERDRIVER

ASSEMBLY
7Once everything is in place, mount the MOLLE panel to the bottom
of the cross bar and front mounting bracket using the same 1/4”-20
hardware. The narrower end of the panel is the front, and the sides should
be pointing up. Finally, go back and tighten all the bolts down fully and
reassemble the overhead console in the reverse order of how you took it
apart.