John Lewis Devon 803/61603 User manual

Stock code 803/61603, 803/61703, 803/61803
Devon 120cm Bed
Thank you for purchasing this Devon bed. Please read the instructions carefully before use to ensure safe
and satisfactory operation of this product.
For product support or spare parts
please call the John Lewis Helpline;
T: 01244 689949
E: [e-mail]
Please check the pack contents before attempting to assemble this product. A full checklist of components
This product is HEAVY, it should be assembled as near as possible to the point of use. TAKE CARE
WHEN LIFTING, to avoid personal injury and (or) damage to the product.
This product takes approximately 60 MINUTES to assemble with 2 PEOPLE.
SMALL PARTS which should be KEPT AWAY FROM YOUNG CHILDREN.
If you require any additional information or have any issues with this product please call the John
Lewis Helpline on 01244 689949 or email [e-mail].

Step 1 Insert dowels (D) in to the pre drilled holes on the side rails (3). Insert barrel nut (C) in to the pre drilled
holes underneath side rails (3) and on the inside top of the side rail (3). Secure the side rails (3) to the
head board (1) using bolts (B) as shown below. Tighten using allen key (A).
Step 2 Attach the other end of side rails (3) on to the foot baord (2) following the same procedure as step 1.

Step 3 Secure the centre rail (4) to the head board (1) and foot board (2), by pushing the bracket down in to
place as shown below.

PLEASE NOTE :
slat to the other end of the bed using screws (G) ensuring there are no gaps between the slats and
head boards. Finally, secure the rest of the slats in to place using screws (G) as shown below.
Tighten using a philips head screw driver.

Wood Furniture
ray’which can appear on oak furniture is a mark of good quality timber - these are just characterisitics of
the natural beauty of the wood. Some furniture is also deliberately aged and rustic.
drawer fronts by the way the slivers are arranged.
All timber surfaces will change colour and mellow over time. New furniture will initially vary in shade
from items that have been previously purchased.
How to care for your wood furniture
Furniture with a hard lacquer, wax polish or painted surface should be dusted with a dry cloth.
Waxed furniture will need to be given a coat of beeswax a couple of times a year to help maintain its
luster.
Spray polishes are best avoided as they contain silicones which may spoil the furniture’s surface by
building up over time.
Our furniture will endure most temperatures in the home but is is best to avoid placing furniture next
caused by central heating can cause damage such as warping.

This product complies with BS 8509 : 2008