John Lewis MICROPLEAT 706 03250 User manual

MICROPLEAT TABLE LAMP
USER GUIDE
Product code
706 03250

Getting started
Thank you for purchasing this Micropleat table lamp. Please read the instructions
carefully before use to ensure safe and satisfactory operation of this product.
Warnings
The supply cable runs through the inside of this product. Take care not to place
undue stress on the cable whilst unpacking to prevent the possibility of a poor
connection.
If you are in any doubt consult a person competent to give advice on the
assembly of electrical equipment.
If the external flexible cable of the lamp is damaged it shall be exclusively
replaced by the manufacturer or his service agent or a similar qualified person in
order to avoid a hazard.
To prevent electrocution switch off at the mains supply before assembling or
maintaining this fitting. Ensure the plug is not connected to any power supply and
read instructions before assembly.
Always be sure to use the correct type and wattage of bulbs as indicated on the
fitting. Never exceed the wattage stated.
When changing the bulb, always switch off at the mains and allow the old bulb to
cool down before handling. Dispose of used bulbs carefully.
Caution! The bulb and surrounding areas can become hot.
Parts List
Ref
Description
Qty
1
Table lamp
1
2
Shade
1
3
Diffuser
1
C
B
A
B
C
A

Product assembly
Step 1
Unpack the product (A) and remove all packaging.
Be careful not to scratch the surface of the product whilst removing the
wrapping.
Step 2
Remove the shade ring already attached to the lamp holder section.
Place the shade over the lamp holder and refit the shade ring to secure
the shade in place.
Step 3
Fit the bulb: type and wattage as indicated on the fitting.
The wattage indicated must not be exceeded.
Step 4
Carefully place the diffuser (C) over the top of the shade until it comes to
rest on the three support tabs at the top.
Your table lamp is now ready to be plugged into the wall socket and is
ready to use.
1
3
4
A
B
C

Product
information
•Indoor use only
•Non-dimmable
•Replacement bulbs should be the same type and rating, available from John Lewis
•Partners or other established brands
Clean the fitting with a soft dry cloth
Aftercare and
troubleshooting
If you experience any unresolvable technical issues with the product, contact your
nearest John Lewis & Partners shop or
John Lewis & Partner Technical Support on 03301 230106.
Why is the light not working when switched on?
Check your power supply is switched on
Turn off light and check that the bulb is inserted correctly
Check the bulb is still in working order.
Specification
Max. power: 28W or 5-7W LED (400-700 lumen) Voltage: 220–240V, 50Hz
IP rating: 20
Weight: 1.3kg
5-year guarantee
At John Lewis & Partners we test every light to high quality standards so we are
able to offer you a 5 year guarantee.
Recycling
This symbol indicates that this product should not be treated as normal
household waste and it should be recycled. John Lewis & Partners do not operate
instore take back, but as members of the Distributor Take Back scheme have
funded the development and upgrade of recycling facilities across the UK.
Please take it to your nearest collection facility or for further details contact your
local council or visit www.recycle-more.co.uk.
IL4380 Issue 1 04/21
John Lewis Plc
171 Victoria Street
London SW1E 5NN
johnlewis.com
Made in China Please retain these instructions for future reference