John Lewis ZENA TWIST User manual

IL3852
User manual
ZENA TWIST LED
FLOOR LAMP

Thank you for purchasing this ZENA TWIST LED FLOOR LAMP.Please read the instructions carefully before use to
ensure safe and satisfactory operation of this product.
Warnings!
The supply cable runs through the inside of this product. Take care not to place undue stress on the cable
whilst unpacking to prevent the possibility of a poor connection.
If you are in any doubt consult a person competent to give advice on the assembly of electrical equipment.
If the external flexible cable of the lamp is damaged it shall be exclusively replaced by the manufacturer or his
service agent or a similar qualified person in order to avoid a hazard.
To prevent electrocution switch off at the mains supply before assembling or maintaining this fitting. Ensure the
plug is not connected to any power supply and read instructions before assembly.
The light source of this luminaire is not replaceable; when the light source reaches the end of its end of life the
whole luminaire shall be replaced.
If moving the floor lamp always carry it from the base. Do not lift the floor lamp by the stem only as damage may
occur.

Assembly
Unpack the lamp and remove all packaging. Be careful not to scratch surfaces of the
product whilst unpacking. Follow the diagram above for fixing details.
1. Lay the product out on the floor. If the floor is not carpeted please cover it with a soft cloth
to avoid damage to the flooring and surface of the product. Assembly should take place
with the product lying flat.
2. Screw the centre pole onto the upper lamp holder section ensuring that the lamp holder
section is kept still and that the pole is threaded on ensuring that the cable does not twist.

3. Insert Turn the base section onto the other sections. Keep the poles parallel to avoid cross
threading. Keep the upper poles stationary and only rotate the base section. 
4. Stand the floor lamp upright and ensure all the assembled parts are fully tightened.
5. Floor lamp is now ready for use.

Care instructions
Wipe clean with a clean dry cloth, when product is switched off and has cooled down.
Recommended bulb
1 x 21W non-replaceable LED
Specifications
Max. Power: 21W
Voltage: 220-240V, 50Hz
Please retain these instructions for future reference.
John Lewis Partnership
171 Victoria Street
London SW1E 5NN
johnlewis.com
Made in China
Issue 1 010/17