John Lewis Bubble Solar stake User manual

LED Information
Integrated LED
4 x 0.06 Watt energy efcient LED
0.20 Lumens output
LED non-replaceable
Specication
Max power: 0.24W
Voltage: 1.2V 1 x Rechargeable AA 500mAh Ni-MH
IP rating: 44
Weight 0.32Kg
Please retain these instructions for future reference.
This symbol indicates that this product should not be treated as normal
household waste and it should be recycled. John Lewis does not operate instore
take back, but as members of the Distributer Take Back scheme have funded the
development and upgrade of recycling facilities across the UK. Please take it to your
nearest collection facility or for further details contact your local council or visit
www.recycle-more.co.uk.
Bubble Solar stake
USER GUIDE
John Lewis Partnership
171 Victoria Street
London SW1E 5NN
Johnlewis.com
Made in China

Thank you for purchasing these Solar bubble stakes. Please read the instructions
carefully before use to ensure safe and satisfactory operations of this product.
Warning!
This light set is for temporary outdoor use.
Contains small parts (choking hazard), Keep away from young children and pets to
prevent injury or harm.
Do not connect the light set electrically to any other light set.
If required, only replace the rechargeable battery with recommended type supplied.
(1 x 1. 2V Rechargeable AA 500mAh Ni-MH)
This product contains a rechargeable battery. Do not dispose of this product in
household waste or a re, batteries may explode or leak.
Parts list
Diagram 1
Assembly
Carefully unpack the carton, make sure all parts are present before assembly.
Care instructions
We recommend cleaning with a soft dry cloth. Do not use abrasive materials as
these will damage the nish.
Step 1
Connect the solar panel to the spike “B”. To avoid damaging the
solar panel, install the ground spike into soft ground and then
slide the solar panel onto the spike.
Step 2
Install the solar panel in direct sunlight and where it will be
exposed for the longest time. Don’t install the solar panel where
shadows from buildings or trees etc. will fall as this will reduce
charging performance. Don’t install the solar panel where
articial or street lighting will fall on the panel.
Step 3
Taking step 2 into consideration for best placement location,
install the 4 LED sticks and solar panel into soft ground.
Consider also a location that will not cause a trip hazard or
obstruction to people or pets. You will nd the spikes inside the
bottom part of the stick. Please remove these and reinsert in
reverse with the pointed end on the outside (take care not to
trap the cables during this assembly step - refer to diagram 1).
Step 4
Before using the light set for the rst time, the batteries will
need to be fully charged. Allow 2 full days of charging before use.
Set the power switch to “ON” and allow a full days charge in
daylight. Switch “OFF” at dusk. Repeat the process the following
morning. For operation, switch the now charged light set to
“ON” for continuous operation. The light set will now
automatically switch on at dusk and recharge during the day.
QtyParts List
A
Qty
B
1
5
Slot the cable
in the cut outs
on the stake