John Lewis KEEGAN User manual

IL3678
User manual
KEEGAN RETRO FLOOR
LAMP

Thank you for purchasing this Keegan retro floor lamp. Please read the
instructions carefully before use to ensure safe and satisfactory operation of
this product.
Warnings!
Always use the correct bulb type with the correct wattage as indicated in
the specification table. Never exceed the Max. power rating. When
changing a bulb always switch off at the mains first and allow the bulb to
cool down before handling. Dispose of used bulbs carefully. The bulb and
surrounding parts can become extremely hot during use.
The supply cable runs through the inside of this product. Take care not to
place undue stress on the cable whilst unpacking to prevent the possibility
of a poor connection.
If you are in any doubt consult a person competent to give advice on the
assembly of electrical equipment.
If the external flexible cable of the lamp is damaged it shall be exclusively
replaced by the manufacturer or his service agent or a similar qualified
person in order to avoid a hazard.
To prevent electrocution switch off at the mains supply before assembling
or maintaining this fitting. Ensure the plug is not connected to any power
supply and read instructions before assembly.
If moving the floor lamp always carry it from the base. Do not lift the floor
lamp by the stem only as damage may occur

Assembly
Unpack the lamp and remove all packaging. Be careful not to scratch surfaces of the
product whilst unpacking. Follow the diagram above for fixing detail.
1. Lay the product out on the floor. If the floor is not carpeted please cover it with a soft cloth
to avoid damage to the flooring and surface of the product. Assembly should take place
with the product lying flat.
2. Use the hex key provided to firstly loosen the grub screw at the base.
3. Remove the shade ring already attached to the lamp holder.
4. Screw the lower pole onto the upper head pole of the item ensuring that the head is kept
still and that the pole is threaded on ensuring that the cable does not twist.
5. Gently pull any excess supply cable through the small hole in the back of the base section
until the lower pole meets the base section.
6. Insert the lower pole into the base section and use the hex key provided to tighten the
grub screws to secure in place.
7. Insert the front section of the lamp holder through the circular metal frame at the top of
the floor lamp as shown in the diagram.
8. Place the metal shade over the top of the lamp holder already situated inside the frame
and secure in place with the shade ring removed earlier. Ensure that the head rotational
component is in the correct position so that the shade tilts both up and down. If the shades
only tilts downwards then the rotation position was incorrect prior to fitting the shade,
adjust rotation and perform steps 6 & 7 again.
9. Stand the floor lamp upright and ensure all the assembled parts are fully tightened.
10. Fit the bulb, type and wattage as indicated on the fitting (bulb not supplied). The
wattage indicated must not be exceeded.
.
11. Floor lamp is now ready for use.

Care instructions
Wipe clean with a clean dry cloth, when product is switched off and has cooled down.
Recommended bulb
1 x 28W E27 (ES) eco halogen GLS bulb
Or
1 x 9W energy saving spiral bulb
Specifications
Max. Power: 40W
Voltage: 230V, 50Hz
Please retain these instructions for future reference.
John Lewis Partnership
171 Victoria Street
London SW1E 5NN
johnlewis.com

Made in China
Issue 1 04/17