John Lewis Isabel User manual

IL3469
User manual
Isabel
Floor lamp

Thank you for purchasing this Isabel floor lamp. Please read the instructions
carefully before use to ensure safe and satisfactory operation of this product.
Warnings!
Always use the correct bulb type with the correct wattage as indicated in
the specification table. Never exceed the Max. power rating. When
changing a bulb always switch off at the mains first and allow the bulb to
cool down before handling. Dispose of used bulbs carefully. The bulb and
surrounding parts can become extremely hot during use.
The supply cable runs through the inside of this product. Take care not to
place undue stress on the cable whilst unpacking to prevent the possibility
of a poor connection.
If you are in any doubt consult a person competent to give advice on the
assembly of electrical equipment.
If the external flexible cable of the lamp is damaged it shall be exclusively
replaced by the manufacturer or his service agent or a similar qualified
person in order to avoid a hazard.
To prevent electrocution switch off at the mains supply before assembling
or maintaining this fitting. Ensure the plug is not connected to any power
supply and read instructions before assembly.
If moving the floor lamp always carry it from the base. Do not lift the floor
lamp by the stem only as damage may occur

Assembly
1. Unpack the product and remove all packaging. Be careful not to
scratch the surface of the product whilst removing the plastic wrapping.
2. Lay the product out on the floor. If the floor is not carpeted please cover
it with a soft cloth to avoid damage to the flooring and surface of the
product. Assembly should take place with the product lying flat.
3. It may be necessary to remove protective packaging (plastic/
cardboard) located at cable entry points of the product.
4. Screw the centre pole onto the decorative shaded head of the item
ensuring that the head is kept still and that the pole is threaded on
ensuring that the cable does not twist.
5. Screw the lower pole onto the centre pole. Hold the centre pole still and
only rotate the lower pole so as not to twist the internal cable.
6. Gently pull the excess cable out of the base until the assembled poles
meet the base.
7. Turn the base section onto the other sections. Keep the poles parallel to
avoid cross threading. Keep the upper poles stationary and only rotate
the base section.
8. Ensure all of the excess cable is removed from the base.
9. Stick the foam pad evenly over the base of the product to protect the
floor when in use.
10. Stand the floor lamp upright and ensure all the assembled parts are fully
tightened. Hold the base still and turn the upper pole sections one by
one, working from the top down in a clockwise direction. This will ensure
all poles are locked tightly against each other.
11. Fit the shade by first removing the shade ring from the lamp holder.
Position the hole in the centre of shade over the lamp holder and
replace shade ring to secure shade in place.
12. Fit the bulb, type and wattage as displayed on the fitting. The stated
wattage must not be exceeded.
13. Floor lamp is now ready for use.

Care instructions
Wipe clean with a clean dry cloth, when product is switched off and has
cooled down.
Recommended bulb
1 x 42W E27 (ES) eco halogen GLS bulb
Or
1 x 11W energy saving spiral bulb
Specifications
Max. Power: 60W
Voltage: 230V, 50Hz
Weight: 4.0kg
Please retain these instructions for future reference.
John Lewis Partnership
171 Victoria Street
London SW1E 5NN
johnlewis.com
Made in China
Issue 2 11/16