John Thomas MISSION COMPUTER STAND 273 User manual

ITEM NO : 273
REVISED MAY 15, 2014 Printed in Vietnam
- 1 -
Description
Item No.
:
MISSION
COMPUTER STAND
: 273
ASSEMBLY INSTRUCTIONS

ITEM NO : 273
REVISED MAY 15, 2014 Printed in Vietnam
- 2 -
Thank you for purchasing this quality product. This product has been designed for easy assembly and
constructed for durability.Please take the time to read and follow the assembly instructions carefully.
Be sure to check all packing material carefully for small parts which may have come loose inside the carton
during shipment. Please separate, identify, and count all parts and metal hardware. Compare with part list to be
sure all parts are present. If hardware is missing or you have difficulty assembling this product, please call Toll
Free: 1-888-944-8396.
IMPORTANT NOTE:
-Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from
being scratched.
-Remove all wrapping material, including staples & packing straps before you start to assemble.
-DO NOT tighten all screwsand bolts until completely assembled.
-Keep all hardware partsout of reach of children.
PART
LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing, please
make sure you have the following par
NO
Description
Q
ty
Sketch
NO
Description
Q
ty
Sketch
A Top 1 D Keyboard tray 1
B Side frame
(L-R) 2
E Center rail 1
F Slide in panel 1
C Bottom
shelf 1
BEFORE ASSEMBLY
ASSEMBLY TOOLS REQUIRED
NOT INCLUDED

ITEM NO : 273
REVISED MAY 15, 2014 Printed in Vietnam
- 3 -
HARDWARE LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing, please
make sure you have all of the following hardware:
NO
Description
Qty
Sketch
NO
Description
Q
ty
Sketch
1 Long bolt
(6x35mm) 8
2 Flat washer
(6.5x19mm) 8
3 Spring washer
(6.5x13mm) 8
4 Wood screw
M4x35mm 2
5 Allen key
(M4x70mm) 1
STEP 1
Attach center rails (E) and side frames (B) with the screws (4) as shown below. Tighten with a
Screwdriver.
Attach the top (A) to the side frames (B) with the bolts (1), and washers (2) and (3) as shown below.
Tighten with Allen key (5).

ITEM NO : 273
REVISED MAY 15, 2014 Printed in Vietnam
- 4 -
STEP 2
Attach the bottom shelf (C) with bolts (1), and washers (2) and (3) as shown below. Tighten with
the Allen key (5)

ITEM NO : 273
REVISED MAY 15, 2014 Printed in Vietnam
- 5 -
STEP 3
Insert the keyboard tray (D) into the unit as shown below.
STEP 4
Slide panel (F) into the grooves underneath the keyboard tray (D) as shown below.