JTS CX-500Du/PS-510M User manual

PS-510M : 1 piece
CX-500Du Miniature microphone : 1 piece
Windscreen (reticular foam cover) : 2 pieces
Dual adhesive : 2 circles
CX-500Du
Type
Frequency Response
Sensitivity (at 1,000Hz)
Impedance
Max.SPL for 1% THD
Signal-To-Noise Ratio
Output Connector
Power Supply
Current Consumption
Weight
Dimensions(mm)
Standard Accessory
Omni-directional Condenser
20 ~ 20,000Hz
-58±3dB*(1.25mV)*0dB=1V/μbar
1.5kΩ
130dB
68dB
4P Mini XLR
1-5 VDC
≤0.05mA
6.5g (including cable)
Ø6mm*13mm(H)
MA-500
Buckle up the Miniature Microphone with Microphone stable.
Tear up dual adhesive from the Microphone stable.
Adjust the Microphone to suitable position.
Stick the Microphone stable on the instrument AB
String Piano.
String Piano
M
The PS-510M is developed based on PS-500. The PS-510M provide
both 9V battery power and phantom power. It is built with earphone
output for musician to monitor a preferred mix of two microphone signals
before goes to P A.
The CX-500Du provides clean, detailed and natural sound quality with a
subminiature golden plated condenser capsule.
CX-500Du / PS-510M
Subminiature Condenser Instrument Microphone / Power supply with personal mix
Thank you for using JTS product. Make sure all parts in the package and read the instruction before using the CX-500Du microphone.
•Do not leave the devices in a high temperature or high humility place.
•Keep the devices away from fire and heat sources.
•Do not use sprays or fluids, which contain chemicals.
Caution
Parts Identification
Specification
Operation 1
1
2
3
4
1
2
3
4
1 2
3PIN2 OUT(+)
PIN3 OUT(−)
(Phantom Power Supply)
Output : 3P XLR (Male)
Pin 1 : GND
Pin 2,3 : Audio signal
1
2
3
4MIC IN
V+
Input : 4P Mini XLR (Male)
Pin 1 : GND
Pin 2 : V+
Pin 3,4 : Audio signal
59010-503-03
Please maintain the temperature in proper status it helps the Subminiature Condenser Instrument Microphone to
lengthen its life. Using the part and Power Supply made from JTS to ensure the unit quality and lifetime. Do not attempt
to employ non-standard Power Supply as you might damage the unit.
1
2
3
4
1 2 3 4A
Soundboard
4B
MIC IN
OUTPUT

PS-510M Dual Input Power Supply With Personal Mix
Thank you for choosing JTS PS-510M Dual Of Supply With Personal Mix.
In order to obtain the best efficiency, you are recommended to read this manual before using.
Case
Audio Input Socket (4P Mini XLR, Male)
Audio Output Socket (3P XLR, Male)
Volume Control
Power On / OFF / Low Batt. Indicator
Phantom / Batt. Switch
On / Mute Switch
Belt Clip
Battery Compartment
Output MIC. / Line Level Switch
Earphone Jack (3.5mm dummy stereo)
Earphone Volume Control
2
Figure 1
Figure 3Figure 2
92
65
23
29.4
Use Instruction
Feature
．PS-510M the Dual input power supply provides 9V(by using a 9V battery) / 12∼48 V(by using power from the mixer)
phantom power to condenser microphones.
．Two mini XLR (M) inputs.
．Separate volume controls can be set independently, which make PS-510M work as a personal mixer.
．Reliable plastic belt clip makes it easy to attach PS-510M to a belt.
．Earphone output for musician to monitor a preferred mix.
．Ideal for CX-500Du Violin microphone and CX-516 accordion microphone.
Parts Identification
3
2
1
1
2
3
4
5
6
7
8
9
10
11
12
6
57
48
9
11
412
MIC. LINE
10
Installation (Figure 1)
1. Connect one or two microphones to the XLR inputs. (IN L / IN R)
2. Connect the XLR output to a mixer by using an audio cable.
3. Switch MIC. / LINE switch to match the output level to the input of the
connected mixer.
Note: The earphone output will work only under battery power.
Operation
1. Insert one piece of 9V battery to the battery compartment.
2. Switch phantom / Batt. to power the PS-510M. (Figure 2)
3. Switch On / Mute: On: Audio output enabled, earphone output disabled,
audio output disabled.
Mute: earphone output enabled.
4. Adjust the volumes of the right and left inputs to have a preferred mix. (Figure 3)
LED Indicator
LED indicator shows the On / OFF / Low Batt. status. (Figure 2)
When the LED lights up GREEN, the PS-510M is ON and the power supply is normal.
Low Batt. : LED RED
Specification
PS-510M
20~20,000 Hz
Batt. Power 9V / 12~48V Phantom Power
max. 20 mA
max. 80mA with Headphone (16Ω/32Ω)
5 k Ω
470 Ω balanced
4P Mini XLR(M) (2 channels)
3P XLR(M)
92mm(W)* 23mm(H)* 65mm(D)
Frequency Response
Power Supply
Current Consumption
Battery
Input Impedance
Output Impedance
Input Connector
Output Connector
Dimension(m/m) PROFESSIONAL CO., LTD.
No. 148, 9th Industry Road, Ta-Li Industrial Park,
Taichung City, Taiwan, R.O.C.
Tel: [phone] Fax: [phone]
E-mail: [email protected]
www.jts.com.tw