Kaba Generation E-760 AUTO DEADBOLT ASM Office User manual

Generation E-760 Installation Instructions
for Auto Deadbolt, Office and Storeroom
STEPS FOR AUTO DEADBOLT ASM • MODELS 76016 & 76017
If not already installed at the factory, put the
thumbturn in the vertical position and install all four
(4)parts (M) as shown, on the inside trim assembly.
Turn the thumbturn all the way to the right for a RH
installation (arrow onM2points UP), or all the way
to the left for a LH installation (arrow onM2points
DOWN). The thumbturn should stop in the vertical
position, and the stopper cam (M2) will be in the posi-
tion illustrated.
Place 3 spacers (S) on the door (for recent models
only). Place the inside trim assembly on the door so
that the upper and lower spindles (F) and (G) engage
the thumbturn and the inside lever. Fasten to the
outside housing using the three 1/8” hex head
mounting screws (I).
Apply the privacy thumbturn sticker as shown. If
in doubt as to the direction of the arrow, press the
auxiliary latch (X) to extend the deadbolt, and verify in
which direction to rotate the thumbturn to reach the
horizontal (privacy) position.
M4
M1
M2
M3
Install clip
M1diagonally
on hub
(TOP)
RH
LH
RH/LHR LH/RHR
X
F
I
G
I
S
S

STEPS FOR ASM OFFICE • MODELS 76112 & 76113
DO THE FOLLOWING BEFORE PLACING THE INSIDE
TRIM ASSEMBLY ON THE DOOR:
Install only parts (M3and M4) as shown, on the
inside trim assembly.
STEPS FOR ASM/ESM STOREROOM • MODELS 76112, 76113, 76131
DO THE FOLLOWING BEFORE PLACING THE INSIDE
TRIM ASSEMBLY ON THE DOOR:
M4
M3
Install M3onto M4, then slide both parts
onto the thumbturn.
Install M2onto M4, then slide both parts
onto the thumbturn.
The thumbturn should be locked in the
vertical position.
M4
M1M2
PK2990/08/12 - GENERATION E-760 INSTALLATION INSTRUCTIONS
Call 1-877-468-3555
or 1-514-340-9025
Put the thumbturn in the vertical position and install
only parts (M2 and M4) as shown, on the inside trim
assembly. The notch on the stopper cam (M2) must
engage the tab on the plate (M4), so that the thumbturn
is locked in the vertical position.
Technical Support