keilhauer Juxta Slab with Power User manual

Juxta Slab with Power
Assembly Guide

Tools Required Hardware Included
Place the slab top upside down on a well-padded flat surface.
Use eight 1/4-20 x 3/4" machine screws to secure the inserts to the top. Hand
tighten the screws first to allow some play for the screws to properly line up. Secure
the screws with a screwdriver once all the screws are aligned.
Once the cord is through, pull the cord from the bottom end while continuing
to feed the power through the top. Ensure that some slack is left in the cord
where the power unit is inserted.
Place the metal leg inserts as shown (note: the wider insert has a cutout to allow
for the power cord).
Place the table on its side and feed the power cord through the table top opening.
Insert the power unit into the cutout. You can hold it in place with masking tape
as it is loose at this point and will fall out when turning the table back into the
upright position.
keilhauer.com
(1) Pneumatic Driver Gun (1) Hex Bit(1) Robertson Bit (16) 1/4-20 x 3/4"
Machine Screws
(4) 1/4-20 x 11/4"
Flat Socket Screws
(4) Glides
1
3
5
2
4
6

Before assembling the first, wider table leg, note the detail, as the channeled
end goes against the underside of the table.
Take out the slack in the cord as the leg is lowered into place.
Assemble the leg glide after the flat socket screw and leave enough thread, as
this will assist in protecting the table leg edge when turning the table back on its legs.
Use two 1/4-20 x 11/4" flat socket screws (one on each end) to secure the plate.
The plate should sit in the pocket, and not sit proud of the leg bottom. If it is sitting
proud the leg has been installed upside-down.
Repeat leg assembly steps (without the power cord) for the second table leg.
The plate should sit in the pocket, and not sit proud of the leg bottom. If it is sitting
proud the leg has been installed upside-down.
While feeding the power cord into the leg, gently lift the leg into place over
the metal leg inserts.
Warning
Ensure that the channeled end
of the slab table leg goes against
the underside of the table, not the
ground, as shown in step 7.
7
9
8
10
11 12

Juxta Slab with Power Designed by EOOS
keilhauer.com
1450 Birchmount Road
Toronto, Ontario, Canada
M1P 2E3
T 416 759 5665
F 416 759 5723
1 800 724 5665
Making sure there is sufficient padding in place to avoid damages, turn the
table onto its legs.
Move the table into place and adjust the glides to provide a level surface.
Clips are included to secure the power unit and cord into place. Push the clips
into the power unit and use a clip and adhesive to secure the cord. Firmly press
the power unit into place.
To access the power ports simply press and release.
Power
Three electrical outlets rated
15A/125VAC and two USB-A
connections for USB powered
devices.
13
15
14
16