keilhauer Juxta User manual

keilhauer.com
1450 Birchmount Road
Toronto, Ontario, Canada
M1P 2E3
T 416 759 5665
F 416 759 5723
1 800 724 5665
Juxta Designed by EOOS

Juxta Rectangle Table
Assembly Guide

Tools Required
Pneumatic
Driver Gun
Hex Bit Hex Allen Key
keilhauer.com
Line up the first base plate with the 4 screw inserts.
Lightly fasten (2) 1/4 - 20 x 5/8“ screws to opposite corners with a hex key.
Slide the crossbar extrusion over the base insert, but do not secure.
Slide in the cross bar extrusion to the second base to connect the structure,
but do not secure.
Lightly fasten (2) 1/4 - 20 x 5/8“ screws with a hex key to secure the second base to
the top.
Fasten both base plates to the table top with the remaining (4) 1/4 - 20 x 5/8“ screws
using a hex key or driver gun.
Line up the second base plate with the 4 screw inserts on the underside of the table top.
Juxta Rectangle Assembly Instructions
Safety Gloves
3
56
12
Secure the cross bar extrusion by fastening the (2) 5/16 - 18 x 1“ set screws with a
hex key or driver gun.
4
7

keilhauer.com
Hardware Included
Tables with Power
Connect the 2 halves of the base together with the crossbar extrusion using the
(2) 5/16 - 18 x 1” set screws, but do not fasten the base to the top.
Feed the power cord through the center of the table top and fit the power box
into the cut out.
Place the table top face down on a soft surface. Fasten the 2 plastic cord management pieces into the corresponding channels using
4 wood screws.
Depending on the location of the power source, run the power cord through the
appropriate channel of the plastic cord management piece.
Before the connected base is fastened to the table top, feed the cord through the leg
and out the bottom of the base.
To hide the power box and cord, screw the power enclosure over the power box using
the (8) 1/4 - 20 x 1/2” screws, and clip the smaller plastic cord management piece over
the cord into the channel.
Ensure the base plates are lined up properly to the holes on the underside of the table
and use the (8) 1/4 - 20 x 5/8“ screws to secure the base to the top.
(8) 1/4 - 20 x
5 / 8 ” h e x s o c k e t
cap screws
(8) 1/4 - 20 x
1 / 2 ” h e x s o c k e t
cap screws
(8) 5/16 - 18 x 1”
hex socket head
set screws
(4) 6-18 x 1/4”
pan head
wood screws
2
3
56
78
4
1