keilhauer Visit User manual

Visit
Assembly Guide

Tools Required
Pneumatic
Driver Gun
Hex Bit Hex Allen Key Adjustable
Wrench or
Socket Set
keilhauer.com
Arrange the benches into the desired configuration, with the benches pushed close
together. Locate the ganging ports on the underside of the benches and line the ganging
plate up with these ports. Insert a hex machine screw, first tightening the screw by hand
to ensure the screw is threading correctly, then use a driver gun to complete.
1 2
Bench-table ganging
Arrange the benches and tables into the desired configuration. Locate the ganging ports
on the underside of the bench and tables (lifting the table so that the underside of the
table is flush with the underside of the bench seat), and refer to Bench-bench ganging to
gange the table to the bench with a ganging plate.
1
Ganging Visit tables and benches with power
For configurations that contain tables with power, a power cord runs along the underside of
the benches and tables, connecting at a power bar at the ganging plate.
1
Screw into the remaining 3 ports in the outer corners of the plate to gang the benches
together.
Safety Gloves
To affix the power bar to the ganging plate, line up the power bar clip to the slots in the
center of the ganging plate and fasten to the plate using an adjustable wrench or socket
and 2 hex screws.
Bench-bench ganging
Hardware Included
5/16–18 x 1
hex machine
screws
Ganging
Plates
Power bars Power bar
clips
Hex screws Wood screws

Once the power bar clip is in place, clip in the power bar to hold it in place. Plug the power cord that is integrated into the bench into the power bar. If multiple
powered benches are ganged together in a configuration, ensure all benches are connected
through the power cord and bar.
2 3
To power the Visit table, plug the table power unit into the power bar. For in-line tables,
the power can be drawn from the bench on either side, providing flexibility to adapt to the
location of the power source.
4
keilhauer.com
To manage the power cord at the end of a configuration, use 2 wood screws and screw a
power bar clip into the underside of the bench. The clip can be screwed in any orientation
or location under the bench, to accomodate differing power source locations.
5
Fit the power bar into the clip.
6
Plug the cord into a wall outlet to power the configuration.
7

keilhauer.com
1450 Birchmount Road
Toronto, Ontario, Canada
M1P 2E3
T 416 759 5665
F 416 759 5723
1 800 724 5665
Visit Designed by EOOS