kingsley-bate LT-60 User manual

KINGSLEY-BATE
Fine Garden Furniture
ASSEMBLY INSTRUCTIONS FOR THE LT-60
RIGHT END FRAME LEFT END FRAME
SEAT BACK
STEP-I
Unpack, inspect and lay the parts on a clean, flat, soft surface to avoid marring the wood.
NOTE: During assembly of the furniture please match joints with the corresponding
letters or numbers stamped on the furniture.
*NOTE
A TENON
B MORTISE HOLE
STEP-II
Fit the BACK tenons into the RIGHT END FRAME
mortise holes. If necessary, gently rock the BACK
while pushing the tenons down into the mortise holes
until the joints fit snugly together.
STEP-III
Place the SEAT against the RIGHT END FRAME as shown in the
assembly diagram and insert the tenons of the center seat braces into
the bottom rail mortise holes of the BACK.
NOTE: There is a front and back to the seat. Please make sure to match
the stamped letters or numbers that you will find on the seat braces
under the SEAT with those on the END FRAMES, BACK or FRONT
SEAT RAIL.
STEP-IV
Place the FRONT SEAT RAIL tenon into the RIGHT END FRAME
mortise hole. Place the SEAT tenons into the FRONT SEAT RAIL
mortise holes.

STEP-V:
Fit the remaining LEFT END FRAME mortise holes over and onto the
BACK and the FRONT SEAT RAIL tenons. Using a rubber mallet or a
regular hammer with a wood block between the hammer and the wood,
drive the tenons and mortise holes until all the joints fit snugly together.
Small dowels Medium dowel Long dowel
Back Top Front Seat Rail Back Bottom Seat Support
STEP-VI
Hammer the dowels into their respective joints. Make sure not to hit other parts of the
bench. To avoid dimpling the wood, we suggest that you place a block of wood between
the dowel head and the hammer head for the last few blows. If the dowels are not
completely flush, use a saw to cut the ends and then sandpaper to smooth the tops.
**DO NOT FORCE DOWELS FURTHER THAN THEY WILL GO. **
STEP-VII
Insert the brass screws into their respective pre-drilled SEAT holes (see
assembly photo). Do not hammer in the screws, but drive them in with
a proper screw driver. Use of a power screwdriver or a drill with a
screwdriver bit could lead to damage of your furniture.
IF YOU HAVE ANY QUESTIONS REGARDING THE ASSEMBLY OF YOUR
KINGSLEY-BATE FURNITURE, PLEASE CONTACT THE KINGSLEY-BATE
DEALER NEAREST TO YOU OR KINGSLEY-BATE DIRECTLY. WE THANK YOU
FOR CHOOSING OUR FURNITURE.
*KINGSLEY-BATE WILL NOT TAKE RESPONSIBILITY FOR DAMAGE
IF THESE INSTRUCTIONS ARE NOT FOLLOWED PROPERLY.
7200 Gateway Court, Manassas, Virginia 20109
Phone: [phone], Fax: [phone]