kingsley-bate Algarve GV52 User manual

Kingsley-Bate
GV52-60 Algarve 52" and 60”Round Dining Table
Assembly Instructions

KINGSLEY–BATE
Fine Garden Furniture
ASSEMBLY INSTRUCTIONS FOR THE GV–52/60
LEGS TABLE TOP CROSS BRACE
* NOTE
A TENON
B MORTISE HOLE
STEP-I
Unpack, inspect and lay the parts on a clean, flat, soft surface to avoid marring the wood.
NOTE: During assembly of the furniture please match all the joints with the corresponding
letters or numbers stamped on the furniture.
STEP-II
Fit the CROSS BRACE tenons in to the LEG m ortise holes
using the stamped numbers or letters as guides.
STEP-III
Fit the LEG ASSEMBLY into the TABLE TOP using the
stamped numbers or letters as guides. Using a rubber m allet
or a hammer with a block of wood between the ham mer and
the wood, drive the tenons and the m ortise holes evenly until
all joints fit snugly together. Insert the two knock down bolts as shown in assem bly pictures.
Secure them with a proper screw driver (using a power screw driver could lead to damage).
STEP-IV
Drive the dowels (as seen in photographs) by using direct
sharp blows with a ham mer (again, please use the sanding
block between the dowels and the hammer for the last few
blows). Do not force the dowels further than they can go and
be careful not to mar the wood. Any protruding dowels can easily be sanded away.
IF YOU HAVE ANY QUESTIONS REGARDING THE ASSEMBLY OF YOUR
KINGSLEY-BATE FURNITURE, PLEASE CONTACT THE KINGSLEY-BATE DEALER
NEAREST TO YOU OR KINGSLEY-BATE DIRECTLY. WE THANK YOU FOR
CHOOSING OUR FURNITURE.
* KINGSLEY-BATE WILL NOT TAKE RESPONSIBILITY FOR DAMAGE IF THESE
0INSTRUCTIONS ARE NOT FOLLOWED PROPERLY
7200 Gateway Court, Manassas, Virginia 20109
Phone: [phone], Fax: [phone]