kingsley-bate Amalfi AM20 User manual

Kingsley-Bate
AM20 Amalfi Side Table
Assembly Instructions

KINGSLEY – BATE
0Fine Garden Furniture
1ASSEMBLY INSTRUCTIONS FOR THE AM - 20
END FRAME TABLE TOP END FRAME
*NOTE
3A TENON
4B MORTISE HOLE
STEP-I
Unpack, inspect and lay the parts on a clean, flat, soft surface to avoid marring the wood.
NOTE: During assembly of the furniture please match all the joints with the corresponding
letter or numbers stamped on the furniture.
STEP-II
Carefully lay the END FRAME with the stam ped numbers on a
flat surface. Making sure that you line up the stam ped tenons of
the TABLE TOP and the BOTTOM LEG STRETCHERS with
those on the END FRAME, gently insert the tenons as shown in
the above diagram . If necessary, gently rock the parts while pushing the tenons into the
mortise holes until all the joints fit snugly t ogether. You may also use a rubber m allet or a
hammer with a block of wood between the hammer and the wood to drive the joints together.
STEP-III
Using a hammer, drive the dowels into place with direct sharp blows. We
suggest that you place a block of w ood between the ham mer head and the
dowel head for the last few blows. This will prevent marring the wood. DO
NOT FORCE DOWELS FURTHER THAN THEY WANT TO GO. Any
protruding dowels can easily be sanded away.
IF YOU HAVE ANY QUESTIONS REGARDING THE ASSEMBLY OF YOUR
KINGSLEY-BATE FURNITURE, PLEASE CONTACT THE KINGSLEY-BATE DEALER
NEAREST TO YOU OR KINGSLEY-BATE DIRECTLY. WE THANK YOU FOR
CHOOSING OUR FURNITURE.
* KINGSLEY-BATE WILL NOT TAKE RESPONSIBILITY FOR DAMAGE
2IF THESE INSTRUCTIONS ARE NOT FOLLOWED PROPERLY
7200 Gateway Court, Manassas, Virginia 20109
Phone: [phone], Fax: [phone]