kingsley-bate LO32 User manual

ASSEMBLY INSTRUCTIONS FOR THE LO32
LEGS SEAT FRAME
HARDWARE
CONNECTOR
CUSHIONS
STEP-I
Unpack, inspect and lay the parts on a clean, flat, soft surface to avoid marring the
Wood.
NOTE: During assembly of the furniture please match joints with the corresponding
letters or numbers stamped on wood.
UPHOLSTERED BACK
BACK CUSHION
SEAT CUSHION
M6 X 50mm
BOLTS HEX M8 X 80mm
SPLIT & FLAT WASHERS
ALLEN KEY 4mm WRENCH
BACK CUSHION
UPHOLSTERED BACKREST

STEP-II
Carefully lay the SEAT FRAME upside down on your clean surface, insert and attach the legs
as shown in the assembly photographs using the M6 x 50mm bolts provided. You may need
to wiggle the legs as you finish tightening the bolts to make sure they are fully secured.
NOTE: DO NOT USE POWER TOOLS AS IT MAY DAMAGE THE ITEM.
STEP-III
Requires two people. With the assistance of a second person, lift the SEAT FRAME up,
rotate it in the air and set it gently back on the ground.
Locate the six holes on the underside of the UPHOLDSTERED BACKREST and take note
of the position of the corresponding holes on the SEAT FRAME. Set the
UPHOLDSTERED BACKREST on the SEAT FRAME as shown in the photographs,
ensuring that the holes in the UPHOLDSTERED BACKREST and SEAT FRAME are
aligned.
Locate the six holes on the underside of the SEAT FRAME that correspond with the holes in
the UPHOLDSTERED BACKREST and insert one each of the M8 x 80mm Hex Bolts,
Spring Washers, and Washers into each hole (see picture showing correct arrangement of
washers). Bolts should be initially threaded by hand to prevent cross-threading.
NOTE: DO NOT TIGHTEN THE BOLTS UNTIL ALL HAVE BEEN PARTIALLY
THREADED. ONCE ALL BOLTS ARE IN PLACE, USE THE WRENCH PROVIDED TO
TIGHTEN THEM SECURELY. BE CAREFUL NOT TO OVERTIGHTEN, AS THIS
CAN CAUSE THE THREADS TO STRIP. NEVER USE A POWER TOOL TO TIGHTEN
THE BOLTS.

STEP-IV
If you are connecting multiple sectional items together the photographs above illustrate
where to attach them. DO NOT ATTACH THEM WHILE ITEM IS UPSIDE DOWN AS
YOU WILL NOT BE ABLE TO UPRIGHT THE ASSEMBLY.
IF YOU HAVE ANY QUESTIONS REGARDING THE ASSEMBLY OF YOUR
KINGSLEY BATE FURNITURE, PLEASE CONTACT KINGSLEY BATE CUSTOMER
SERVICE AT 703-361-7000. WE THANK YOU FOR CHOOSING OUR FURNITURE.
* KINGSLEY BATE WILL NOT TAKE RESPONSIBILITY FOR DAMAGE
IF THESE INSTRUCTIONS ARE NOT FOLLOWED PROPERLY
7200 Gateway Court, Manassas, Virginia 20109
Phone: [phone], Fax: [phone]