kingsley-bate Ipanema IP30 User manual

Kingsley-Bate
IP30 Ipanema Lounge Chair
Assembly Instructions

KINGSLEY–BATE
Fine Garden Furniture
0ASSEMBLY INSTRUCTIONS FOR THE IP–30/55/80
RIGHT END FRAME BACK LEFT END FRAME
* NOTE
A TENON
B MORTISE HOLE
SEAT FRAME
SEAT SCREEN
STEP-I
Unpack, inspect and lay the parts on a clean, flat, soft surface to avoid marring the wood.
NOTE: During assembly of the furniture please match joints with the corresponding letters or
numbers stamped on the wood.
STEP-II
Gently lay the END FRAME with the stamps near the mortise holes on
a clean, flat surface and fit the BA CK and SEAT FRAME tenons into
the END FRAME mortise holes. If n ecessary, gently rock the parts
while pushing down on them until all the joints fit snugly together.
NOTE: END FRAME DOES NOT LAY FLUSH ON THE GROUND,
PLEASE BE CAREFUL NOT TO FORCE PARTS TO THE POINT OF DAMAGING THE
END FRAME.
STEP-III
Carefully fit the remaining END FRAME mortise holes over all exposed
tenons and using a rubber m allet or a regular hammer with the sanding
block between the hammer and the wood, gently drive the mortise holes
onto the tenons until all joints fit snugl y together. Carefully upright the
chair by lifting it up and setting it down, tilting the chair over m ight
damage un-doweled tenons.

STEP-IV
Carefully hammer the proper dowels into the
pre-drilled holes of the assem bly, details are
shown in the photographs and all dowels
(and/or dowel bags) are m arked to m atch
where they go.
NOTE: DO NOT FORCE THE DOWELS; ANY EXCESS CAN EASILY BE SANDED
AWAY. IF THE DOWELS ARE NOT FLUSH DO NOT CONTINUE TO DRIVE THE
DOWELS, YOU MIGHT DAMAGE THE ITEM.
STEP-V
Place SEAT SCREEN into SEAT FRAME as shown in photograph.
1IF YOU HAVE ANY QUESTIONS REGARDING THE ASSEMBLY OF YOUR
KINGSLEY-BATE FURNITURE, PLEASE CONTACT THE KINGSLEY-BATE DEALER
NEAREST TO YOU OR KINGSLEY-BATE DIRECTLY. WE THANK YOU FOR
CHOOSING OUR FURNITURE.
* KINGSLEY-BATE WILL NOT TAKE RESPONSIBILITY FOR DAMAGE
IF THESE INSTRUCTIONS ARE NOT FOLLOWED PROPERLY
7200 Gateway Court, Manassas, Virginia 20109
Phone: [phone], Fax: [phone]