kingsley-bate CO-30 User manual

KINGSLEY–BATE
Fine Garden Furniture
ASSEMBLY INSTRUCTIONS FOR THE CO-30/55/80
BACK SEAT INSERTS SEAT
*NOTE
A TENON
B MORTISE HOLE
END FRAME END FRAME
STEP-I
Unpack, inspect and lay the parts on a clean, flat, soft surface to avoid marring the wood.
NOTE: During assembly of the furniture please match all joints with the corresponding
letters or numbers stamped on the furniture.
STEP-II
Carefully lay down the END FRAME with the stamped numbers or letters
on it and fit the SEAT & BACK tenons into the END FRAME mortise
holes as shown in the assembly photograph. If necessary, gently rock the
SEAT & BACK while pushing the tenons into place until the joints fit
snugly together (use a rubber mallet to drive the joints together if
necessary).
STEP-III
Fit the remaining END FRAME mortise holes over and onto all exposed
tenons. Using a rubber mallet or regular hammer with a wood block
between the hammer and the wood, drive the tenons and mortise holes
until all the joints fit snugly together.

STEP-IV
Hammer the dowels into their respective
joints (dowel bags are marked according to
where they go). Make sure not to hit other
parts of the bench. To avoid dimpling the
wood, we suggest you place a block of wood
between the dowel head and the hammer head for the last few blows. If dowels are not
completely flush, use a saw to cut the ends and then sandpaper to smooth the top. * After
hammering, if dowels still protrude DO NOT FORCE!
STEP-V
Place INSERTS into SEAT as shown In photograph.
IF YOU HAVE ANY QUESTIONS REGARDING THE ASSEMBLY OF YOUR
KINGSLEY-BATE FURNITURE, PLEASE CONTACT THE KINGSLEY-BATE DEALER
NEAREST TO YOU OR KINGSLEY-BATE DIRECTLY. WE THANK YOU FOR
CHOOSING OUR FURNITURE.
* KINGSLEY-BATE WILL NOT TAKE RESPONSIBILITY FOR DAMAGE
IF THESE INSTRUCTIONS ARE NOT FOLLOWED PROPERLY
7200 Gateway Court, Manassas, Virginia 20109
Phone: [phone], Fax: [phone]