kingsley-bate CO-30SR User manual

ASSEMBLY INSTRUCTIONS FOR THE CO-30SR
RIGHT END FRAME BACK LEFT END FRAME
SEAT FRAME SEAT INSERT BASE
STEP-I
Unpack, inspect and ay the parts on a c ean, f at, soft surface to avoid marring the wood.
NOTE: During assemb y of the furniture p ease match joints with the corresponding etters or
numbers stamped on the wood. Do not remove cardboard ro s from bottom of BASE unti
fu y assemb ed.
STEP-II
Gent y ay the END FRAME with the stamps near the
mortise ho es on a c ean, f at surface and fit the BACK,
and the SEAT FRAME tenons into the END FRAME
mortise ho es. If necessary, gent y rock the parts whi e
pushing down on them unti a the joints fit snug y
together.

STEP-III
Carefu y fit the BASE with the cardboard ro s into the
SEAT FRAME as shown in the photograph. P ace
remaining END FRAME mortise ho es over and onto a
exposed tenons and using a rubber ma et or a regu ar
hammer with the sanding b ock between the hammer and
the wood, gent y and even y drive a the joints unti they
fit snug y together.
STEP-IV
Hammer dowe s into respective joints making sure not to hit other parts of the bench.
“(dowe bags are marked according to where they go).” To avoid dimp ing the wood, we
suggest you p ace a b ock of wood between the dowe head and the hammer head for the ast
few b ows. Long dowe s for ho es stamped with “L”. Short dowe s for ho es stamped with
“S”. DO NOT FORCE DOWELS FURTHER THAN THEY WANT TO GO; any excess can
be easi y cut off with a saw and sanded smooth. Remove cardboard from base, upright chair
and drop the SEAT INSERT into p ace.
IF YOU HAVE ANY QUESTIONS REGARDING THE ASSEMBLY OF YOUR
KINGSLEY BATE FURNITURE, PLEASE CONTACT THE KINGSLEY BATE DEALER
NEAREST TO YOU OR KINGSLEY BATE DIRECTLY. WE THANK YOU FOR
CHOOSING OUR FURNITURE.
* KINGSLEY-BATE WILL NOT TAKE RESPONSIBILITY FOR DAMAGE
IF THESE INSTRUCTIONS ARE NOT FOLLOWED PROPERLY
7200 Gateway Court, Manassas, Virginia 20109
Phone: [phone], Fax: [phone]