kingsley-bate Amalfi AM50 User manual

Kingsley-Bate
AM50 Amalfi Round Dining Table
Assembly Instructions

KINGSLEY–BATE
Fine Garden Furniture
ASSEMBLY INSTRUCTIONS FOR THE AM-50
LEGS TABLE TOP BASE
* NOTE
A TENON
B MORTISE HOLE
STEP-I
Unpack, inspect and lay the parts on a clean, flat, soft surface to avoid marring
the wood.
NOTE: During assembly of the furniture please match all the joints with the corresponding
letters or numbers stamped on the furniture.
STEP-II
Carefully lay the TABLE TOP face down on a flat, smooth surface. Insert
all four LEGS into the top matching the numbers or letters stamped on the
tenons. If necessary, gently rock the parts while pushing the tenons into
the mortise holes until joints fit snugly together.
STEP-III
Line up the BASE m ortise holes with the matching tenons of the LEGS.
Using a rubber m allet or a ham mer with a block of wood between the
hammer head and the wood, drive the tenons and the m ortise holes
together until all joints fit snugly together. DRIVE BASE EVENLY TO
AVOID DAMAGING THE FACTORY JOINTS.
STEP-IV
Drive the dowels through the tenons of the LEGS where
they meet the BASE and the TABLE TOP. Drive the dowels
by using direct sharp blows with a hammer. Do not force the
dowels further than they can go and be careful not to mar the
wood. Any protruding dowels can easily be sanded away.
IF YOU HAVE ANY QUESTIONS REGARDING THE ASSEMBLY OF YOUR
KINGSLEY-BATE FURNITURE, PLEASE CONTACT THE KINGSLEY-BATE DEALER
NEAREST TO YOU OR KINGSLEY-BATE DIRECTLY. WE THANK YOU FOR
CHOOSING OUR FURNITURE.
* KINGSLEY-BATE WILL NOT TAKE RESPONSIBILITY FOR DAMAGE IF THESE
0INSTRUCTIONS ARE NOT FOLLOWED PROPERLY
7200 Gateway Court, Manassas, Virginia 20109
Phone: [phone], Fax: [phone]