kingsley-bate DN-40 User manual

KINGSLEY–BATE
Fine Garden Furniture
ASSEMBLY INSTRUCTIONS FOR THE DN/HP/SG-40/50/60
RIGHT END FRAME BACK LEFT END FRAME
* NOTE :
A TENON
B MORTISE HOLE
STEP-I
Unpack, inspect and lay the parts on a clean, flat, soft surface to avoid marring the wood.
NOTE: During assembly of furniture please match joints with the corresponding letters or
numbers stamped near the joints.
STEP-II
Carefully lay the END FRAME with the stamps on a clean, flat surface and fit
the BACK tenons into the END FRAME mortise holes as shown. If
necessary, gently rock the BACK while pushing the tenons into the mortise
holes until joints fit snugly together.
STEP-III
Place SEAT against END FRAME as shown on assembly photo and insert
back center SEAT support tenon into bottom rail of BACK mortise hole.
STEP-IV
Place FRONT SEAT RAIL tenon into end frame mortise hole (make sure
rounded edge of FRONT SEAT RAIL is facing up). Place center SEAT
support tenon into FRONT SEAT RAIL mortise hole.

STEP-V
Fit the remaining END FRAME mortise holes over and onto all exposed
tenons as shown in photo. Using a rubber hammer or regular hammer with a
wood block between the hammer and the wood, drive the tenons and mortise
holes together until all joints fit snugly. NOTE: Upright bench by LIFTING
and SETTING down, tilting bench over while dowels are not secured could
cause damage to the bench.
STEP-VI
Hammer dowels into respective joints making
sure not to hit other parts of the bench. To
avoid dimpling the wood, we suggest you
place a block of wood between the dowel head
and the hammer head on the last few blows. If dowels are not completely flush, use a saw to
cut the ends and then sandpaper to smooth the tops. DO NOT FORCE DOWELS FURTHER
THAN THEY WILL GO.
STEP-VII
Insert brass screws into respective pre-drilled holes under the SEAT as shown
in the photo. Do not hammer in the screws, but drive them in with a proper
screw driver; use of a power screw driver could easily strip the holes.
STEP-VIII
Attach the decorative brackets to the END FRAMES and to
the FRONT STRETCHER. Make sure the longest end of the
bracket fits under the FRONT STRETCHER. Brackets are for
decorative use only.
IF YOU HAVE ANY QUESTIONS REGARDING THE ASSEMBLY OF YOUR
KINGSLEY-BATE FURNITURE, PLEASE CONTACT THE KINGSLEY-BATE DEALER
NEAREST TO YOU OR KINGSLEY-BATE DIRECTLY. WE THANK YOU FOR
CHOOSING OUR FURNITURE.
*KINGSLEY-BATE WILL NOT TAKE RESPONSIBILITY FOR DAMAGE
IF THESE INSTRUCTIONS ARE NOT FOLLOWED PROPERLY.
7200 Gateway Court, Manassas, Virginia 20109
Phone: [phone], Fax: [phone]