kingsley-bate CB-53 User manual

KINGSLEY BATE
Fine Garden Furniture
ASSEMBLY INSTRUCTIONS FOR THE CB-53/60
BACK PANEL BOTTOM FRONT PANEL
LEFT & RIGHT SIDE PANELS HANDLES LID
* NOTE:
A TENON
B MORTISE HOLE
STEP-I
Unpack, inspect and lay the parts on a clean, flat, soft surface to avoid marring the wood.
NOTE: During assembly of the furniture please match all joints with the corresponding
letters or numbers stamped on the furniture.
STEP-II
Carefully place the BACK PANEL on a smooth, flat surface with the
mortise holes facing up. Matching the stamped numbers on the tenons
with those next to the mortise holes, gently insert the LEFT and RIGHT
SIDE PANELS and the BOTTOM into position as shown in the
photograph.
STEP-III
Fit the FRONT PANEL over and onto the exposed tenons and using a
rubber mallet, drive all joints together evenly. If you use a hammer, put
the sanding block between the hammer head and the wood to prevent any
damage or marring of the wood.
STEP-IV
Drive locking dowels into place with a hammer. Use the sanding block
between the hammer head and the dowel to prevent marring of the wood.
If dowel protrudes above the wood, sand it level with sanding block
provided. Make sure to sand along grain of the wood. DO NOT FORCE
DOWELS.
HYDRUALICS
KD BOLTS

STEP-V
From inside the box, insert 2 brass bolts fitted
with one washer each. Slide 2 additional
washers over the exposed threads on the outside
of the box and using a proper screw driver,
secure the handle into place; repeat on other side of box. Use of power screw driver could
cause damage to the hardware or wood.
STEP-VI
Mount the lid with the 6mm brass knock down bolts.
Insert and slightly tighten all bolts by hand before
tightening with a proper screw driver. NOTE: THIS
WILL BE EASIER TO DO WITH 2 PEOPLE. YOU
DO NOT WANT TO LET THE WEIGHT OF THE
LID FALL BACKWARDS DURING ASSEMBLY.
STEP-VII
Gently pop hydraulics into place as shown in photographs. Please note that
the black cylinder of the hydraulic attaches to the box and the steel shaft
attaches to the lid.
NOTE: Before installation wipe any excess fluid from the hydraulic casing
to prevent staining of the teak. Periodic inspection and wiping of your
hydraulics will help prevent sediment from entering the casing and damaging
the product. When fully open the lid will stay in the open position. To
close, gently push forward and allow the lid to drop freely; DO NOT
FORCE LID DOWN AS YOU CAN DAMAGE THE ITEM.
IF YOU HAVE ANY QUESTIONS REGARDING THE ASSEMBLY OF YOUR
KINGSLEY BATE FURNITURE, PLEASE CONTACT KINGSLEY BATE CUSTOMER
SERVICE AT 703-361-7000. WE THANK YOU FOR CHOOSING OUR FURNITURE.
* KINGSLEY BATE WILL NOT TAKE RESPONSIBILITY FOR DAMAGE
IF THESE INSTRUCTIONS ARE NOT FOLLOWED PROPERLY*
7200 Gateway Court, Manassas, Virginia 20109
Phone: [phone], Fax: [phone]