kingsley-bate TR-30 User manual

KINGSLEY –BATE
Fine Garden Furniture
ASSEMBLY INSTRUCTIONS FOR THE TR - 30
LEGS TABLE TOP BASE
STEP-I
Unpack, inspect and lay the parts on a clean, flat, soft surface to avoid
marring the wood.
NOTE: During assembly of the furniture please match all joints with the
corresponding letters or numbers stamped on the furniture.
*NOTE:
A TENON
B MORTISE HOLE
STEP-II
Place the TABLE TOP face down and carefully insert the LEG
tenons into their respective mortise holes on the underside of the
TABLE TOP. Tenons of the LEGS will be stamped with a number
or letter to correspond with their respective mortise holes on the
TABLE TOP.
STEP-III
Carefully take the BASE and insert the LEG tenons into their
respective mortise holes. Again, please be sure to line up the
stamped numbers or letters. Using a rubber mallet or a regular
hammer with a wood block between the hammer and the wood,
drive the tenons and mortise holes together until all the joints fit
snugly together.

STEP-IV
Place the table upright and drive the wooden dowels through the
tenons of the LEGS using direct sharp blows from a hammer. To
avoid marring the wood please use a block of wood between the
dowel head and the hammer head for the last few blows. Do not
force dowels; any excess can easily be sanded away.
STEP-VI
Insert all screws into pre-drilled holes using a proper screw
driver as shown in the diagram. Use the small teak plugs to
cover the screws.
IF YOU HAVE ANY QUESTIONS REGARDING THE ASSEMBLY OF YOUR
KINGSLEY-BATE FURNITURE, PLEASE CONTACT THE KINGSLEY-BATE
DEALER NEAREST TO YOU OR KINGSLEY-BATE DIRECTLY. WE THANK YOU
FOR CHOOSING OUR FURNITURE.
*KINGSLEY-BATE WILL NOT TAKE RESPONSIBILITY FOR DAMAGE IF THESE
INSTRUCTIONS ARE NOT FOLLOWED PROPERLY.
7200 Gateway Court, Manassas, Virginia 20109
Phone: [phone], Fax: [phone]