kingsley-bate MK-30 User manual

ASSEMBLY INSTRUCTIONS FOR THE MK-30
RIGHT END FRAME SEAT INSERT LEFT END FRAME
BACK SEAT FRAME HARDWARE
* NOTE
A TENON
B MORTISE HOLE
STEP-I
Unpack, inspect and lay the parts on a clean, flat, soft surface to avoid marring the wood.
NOTE: During assembly of the furniture please match joints with the corresponding letters or
numbers stamped on the wood.
STEP-II
Gently lay the END FRAME with the stamps near the
mortise holes on a clean, flat surface and fit the BACK
and SEAT FRAME tenons into the END FRAME
mortise holes. If necessary, gently rock the parts while
pushing down on them until all the joints fit snugly
together.

STEP-III
As shown in the photos above, carefully fit the remaining END FRAME mortise holes over all
exposed tenons and using a rubber mallet or a regular hammer with the wood block between
the hammer and the wood, gently drive all the mortise holes onto the tenons until all joints fit
snugly together. Insert all hardware and tighten with Allen key provided.
STEP-IV
Flip the chair upside down. Carefully hammer
the proper dowels into the pre-drilled holes of
the assembly. Details are shown in
photographs and all dowels (and/or dowel
bags) are marked to match where they go. To
prevent marring the wood, use the wood block
between the dowel and the hammer head for
the last few blows. NOTE: DO NOT FORCE THE DOWELS; ANY EXCESS CAN
EASILY BE SANDED AWAY. IF THE DOWELS ARE NOT FLUSH, DO NOT
CONTINUE TO DRIVE THE DOWELS, YOU MIGHT DAMAGE THE ITEM.
STEP-V
Place the SEAT INSERT into SEAT FRAME as
shown in photograph.
IF YOU HAVE ANY QUESTIONS REGARDING THE ASSEMBLY OF YOUR
KINGSLEY BATE FURNITURE, PLEASE CONTACT KINGSLEY BATE CUSTOMER
SERVICE AT 703-361-7000. WE THANK YOU FOR CHOOSING OUR FURNITURE.
* KINGSLEY BATE WILL NOT TAKE RESPONSIBILITY FOR DAMAGE
IF THESE INSTRUCTIONS ARE NOT FOLLOWED PROPERLY
7200 Gateway Court, Manassas, Virginia 20109
Phone: [phone], Fax: [phone]